SEVENPOWER EZ-S Bluetooth Selfie Stick User Manual
- June 5, 2024
- SEVENPOWER
Table of Contents
EZ-S Bluetooth Selfie Stick
User Manual
Compatible
How to use
- The long press will open in 2 seconds. When the machine is turned on, the LED Indicator flashes and matches with Bluetooth ” Selfie ” by mobile phone search. The LED Indicator will go out after matching with the mobile phone.
- Click the button to take a picture and the LED flashes once.
- There is no pairing connection status for 180s and automatically shuts down.
- In the matching connection state, 600s without any action automatically shut down.
- Press and hold for 3s to turn it off, and when off, the LED flashes 3 times.
Remove the remote control
Pull out the lever and slide it up to take out the remote control.
How to replace the battery
The remote control cover can be opened from the grooves on both sides.
360° rotary clip
Free to flipTake pictures from multiple angles, and Take photos more freely.
How to open a tripod
Open it in the position of the handle and it will become tripod mode.
Tripod mode
When changing the selfie stick to tripod mode, pull out the last section of the stick and adjust it until the tripod is stable.
Specifications
- Material: Stainless Steel
- Total Length:1000mm
- Collapsed Length:190mm ‘Total Weight:196g
- Battery: CR1632(can change)
REMIND
Selfie stick compatible with Android 4.2.2 and iPhone ios 5.0 and above
(Android devices:lf you change your “Volume key function”, be sure to change
it into default, or lake a picture” to let the selfie stick normal lying).
Thank you for your support!
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
the manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.