oe electrics INSTR1299 Connecting Shoe Panel Instruction Manual
- June 3, 2024
- oe electrics
Table of Contents
QIKPAC M2F (Charging)Connecting Shoe
Panel installation instructions
INSTR1299
INSTR1299 Connecting Shoe Panel
NOTE: M2F Connecting Shoe is used for Charging Applications
-
Cutout Dimensions
Single Connecting Shoe
-
Align Connecting Shoe(s) with cutout and snap into place
-
Connect GST08 interconnecting cable to PSU.
With the PSU upside down align the cable with the writing facing up to slot it into place. Cable retention clip shown in blue
-
Connect another end of the GST08 interconnecting cable to the middle connector on the underside of connecting the shoe with writing on the cable facing up
-
Power inputs and outputs
-
Cable retention clips shown in blue
-
Cable tie GST08 cable into place
Slide cable tie-through slot
Fold cable tie over cable(s)
Tighten the cable tie & remove excess
-
Connect GST18i3 cable to PSU
Complete
See separate instructions for mounting PSU
here: https://www.oeelectrics.co.uk/2020/12/qikfit-30-psu/ -
Cutout Dimensions
Multiple Connecting Shoes
The above cutout should be used with a short GST08 cable –
Part code: 2720960 – GST08-175 MF/W. Larger gaps would require a longer GST08
cable please enquire. -
Connect multiple shoes together using GST08 interconnecting cable(s) using the correct GST08 output and input*** on the next shoe. Ensure writing on the GST08 cable is acting up
-
Repeat Step 2 for how to fit connecting shoes into the cutout then Connect the GST18i3 cable to PSU
Complete 3 connecting shoes. Maximum of 3
connecting shoes per PSU
UK – [email protected] / +44 (0)
1924 367 255
AUS – [email protected] / 1300 ELSAFE
(357 233)
DE – [email protected] / +49 (0)2261 958
3001
U.S.A – [email protected] / +1
(844)-927-0600
www.oeelectrics.com
Documents / Resources
| oe
electrics INSTR1299 Connecting Shoe
Panel
[pdf] Instruction Manual
INSTR1299 Connecting Shoe Panel, INSTR1299, Connecting Shoe Panel, Shoe Panel,
Panel
---|---