Q Q Watches OD14077 SECONDS CARTOON MULTI-FUNCTION SPORTWATCH User Guide
- June 5, 2024
- Q Q Watches
Table of Contents
Q Q Watches OD14077 SECONDS CARTOON MULTI-FUNCTION SPORTWATCH
ATTENTION
- Never try to open the case or remove its back cover.
- Do not operate buttons underwater.
- Should moisture appear inside the watch, have it checked immediately by your dealer. Otherwise, it can cause erosion of the metal parts of the watch.
- Though the watch is designed to withstand normal use, you should avoid rough use or dropping the watch.
- Avoid exposing the watch to temperature extremes.
- Wipe the watch with dry , soft cloth only. Avoid allowing it to come into direct contact with chemical materials, which can cause deterioration of the plastic parts of the watch.
- Avoid wearing the watch in electromagnetic, static conditions.
BUTTONS
Button operations are indicated using the letters shown in the illustration.
- Reset
- Mode
- EL Backlight
- Start/Stop
DISPLAY
The screen is shown in below:
ADJUST HANDS
- Pull out the crown, turn to adjust the hour and minutes hands;
- Push the crown go back the normal position after the time set;
MODE SELECTION
Press “B” to change mode to mode in the following Sequence:
- Timekeeping Mode
- Stopwatch Mode
- Countdown Mode
- Alarm Mode
- Dual Time Mode
- Pacer Mode
TIMEKEEPING
- 12/24H Format;
- Hour, Minutes, Seconds, Month, Date.Day of the week;
- 100 years Calendar(2000-2099).
STOPWATCH
- 1/100 second unit;
- Measuring range:
COUNTDOWN
- Countdown range:
- 23:59’59” – 0’00″00.
ALARM
- 5Alarms;
- Hourly time signal;
- The alarm sounds at the preset time each day.
DUAL TIME
- The time for other timezone.
PACER
- 10 tempi.
TIMEKEEPING
- 12/24H Format
- In the timekeeping mode, Press “D” to switch between 12/24 formats.
- Time Setting
1. In the timekeeping mode press and hold”A” until the seconds to flash; (flashing indicated in set mode)
2. Press “D” to reset the seconds;
3. Press “B” to change the next election;
4. Press “D” to increase the number, press and hold to increase at high speed;
5. Repeat step 3 and 4,the selection in the following sequence: Seconds – Hour- Minutes -Year- MonthDate;
6. Press “A” to exit the set state, after you set (The day of the week is auto displayed in accordance with the year. month, and date setting). BACKLIGHT
-
The backlight that uses an EL(electro-luminescent) causes the display to glow for easy reading in the dark.
Use EL Backlight -
In the timekeeping mode press “C” to illuminate the display for about 3 seconds.
STOPWATCH
- LapTime
1. In the stopwatch mode, press “D” to start the stopwatch;
2. To stop the stopwatch by pressing “D” again;
3. Press “A” to reset the stopwatch.- Split Time
1. In the stopwatch mode press “D” to start the stopwatch;
2. Press “A” to display the split time, stopwatch timing continues internally;
3. Press “A” to clear the split time and to continue time measurement;COUNTDOWN
When the countdown reaches zero.the alarm sounds for about 60 seconds and
press any button to break it.
Countdown Timer Setting
- In the countdown mode, press “A” the hour to flash; (flashing indicated in set mode)
- Press “D” to increase the hour , press and hold to increase at high speed;
- Press “B” to select the minutes;
- Press “D” to increase the minutes, press and hold to increase at high speed;
- Repeat step 3 and 4,the selection in the following sequence: Hour- Minutes – Seconds;
- Press “A” to exit the set state , after you set.
ALARM
The alarm sounds at the preset time each day for about 60 seconds,press any button to break it.
Alarm and Chime
-
1. In the alarm mode, press “C” to select chime, Alarm1 -Alarm5.- In the chime state, press “D” to on/off the chime .
- lntheAlarm1-Alarm5state, press “D” to on/off the alarm.
Alarm1 Setting
-
* In the alarm mode, press “A” the hour to flash(flashing indicated in set mode);- Press “D” to increase the hour, press and hold to increase at high speed;
- Press “B” to select the minutes;
- Press “D” to increase the minutes, press and hold to increase at high speed;
- Press “A” to exit the set state, after you set.
DUAL TIME
Dual Time Setting
- In the dual time mode, press “A” the hour to flash; (flashing indicated in set mode)
- Press “D” to increase the hour, press and hold to increase at high speed;
- Press “B” to select the minutes;
- Press “D” to change the minutes ; (press once to change 30 minutes)
PACER
- Use The Pacer
- In the pacer mode, the tempo number flash;
- Press “A” and select the tempo in the following sequence: 10 – 20 – 30 – 40 – 60 – 80 – 120 – 160 – 240 – 320;
- Press “D” to start;
- To stop it press “D” again.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>