PROAIM CM-ISGP-01 Iso-Grip Vibration Isolator Car Camera Suction Mount User Manual
- June 3, 2024
- PROAIM
Table of Contents
PROAIM CM-ISGP-01 Iso-Grip Vibration Isolator Car Camera Suction Mount
User Manual
What’s In The Box
Please inspect the contents of your shipped package to ensure you have
received everything that is listed below.
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or
transmitted by any form or by any means,
electronic, mechanical, photo-copying, recording, or otherwise, except as may
be expressly permitted by the applicable copyright statutes or in writing by
the Publisher.
Iso-Grip Vibration Isolator Setup
-
Remove the black dust covers of the Suction Car Mount.
-
Open the quick lock lever manually, as shown in the image.
-
Place your first suction cup on selected position where you want to shoot and Mount the suction cup gripper on a flat surface, as shown in the image.
-
Press the lever of the Suction Cup Gripper and lock it properly.
NOTE: It has three powerful suction cups that grip like glue on any non-porous surface and firmly hold your setup when moving at high speeds.
-
Loosen the quick lock, set the position according to your setup requirement, and tighten it properly.
NOTE: Its three articulating arms let you position your camera gimbal set up at practically any angle. -
Place the DJI-QR Plate onto the Suction Car Mount.
-
Then insert an Allen CSK Bolt and tighten properly using a 4mm Allen key.
-
Follow the same process on the other Allen CSK Bolt.
-
Loosen the knob of the DJI-QR Plate.
-
Slide the DJI-Ronin Gimbal (Not Included) into the plate and secure it with the knob of the QR Plate.
NOTE: If the QR Plate is loose, tighten its bolt properly using a 2.5 mm Allen Key.
- Here is proper assembled image of Suction Car Mount & mount. your DJI-Ronin Gimble (Not Included) of your choice as shown.
NOTE: You can use the wires in different configurations depending on the load capacity of your setup.
NOTE: It has wire cable blocks that absorb inertial movements and support a
3-10 kg / 6-22lb heavy payload; Use these blocks in different configurations
to precisely achieve the lift needed.
Load Adjustment, Removable Cables & Tie-Down Blocks
YOUR PROAIM ISO-GRIP VIBRATION ISOLATOR CAR CAMERA SUCTION MOUNT ALL DRESSED UP AND READY TO GO!
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>