AVATIME 9142DT24H Digital Dual Event Timer with Clock Instructions

Table of Contents

Digital Dual Event Timer with Clock

INSTRUCTIONS
9142DT24H

Carefully removthe e plastic strip frothe m battery compartment.
This is included to preserve battery life. Remove ﬁlm from LCD display.

Hand wash only. Do not immerse in water or put in the dishwasher.

Slide the switch located on the back of the timer for either alarm mode or silent, red LED ﬂashing light mode.

To Program Clock:
1. To begin set up, press and hold START/STOP for 4 seconds until the colon no longer ﬂashes.
2. Press MODE to toggle between 12 hour and 24 hour clock.
3. Press HOUR, MIN, and/or SEC to set the desired time. Press and hold each button for fast advance.
4. Press START/STOP to save.

• To Program Timer 1:

Press T1/T2 to select Timer 1. The Timer 1 icon will be on the display.
Press HOUR, MIN, and/or SEC for desired time. Press and hold each button for fast advance.
Press START/STOP to start the count down. Press again to pause and resume the count down.
When time counts down to zero, the alarm will sound or the light will ﬂash. “TIMES UP” and the Timer 1 icon will ﬂash on the display. Press any button to stop the alarm/light. The alarm/light will automatically turn of after 1 minute, but the “TIMES UP” and Timer 1 icon will continue to ﬂash until any button is pressed.
After pressing any button to stop the alarm/light, the timer will recall the previously selected time.
To clear the time back to zero, press HOUR and MIN simultaneously.

Press T1/T2 to select Timer 2. The Timer 2 icon will be on the display.
Follow timer setting instructions as listed under Timer 1.
When both timers are in use, press T1/T2 to toggle between both timers. The icon on the display will indicate which timer is active. Note: a timer must be active to adjust the time or pause and resume time.
To view other modes while counting down, press MODE to enter the Alarm Clock or Clock modes. “TIMER” will ﬂash on the display to show the timer is still counting down. When a timer reaches zero, the alarm will sound or the light will ﬂash, and “TIMES UP” and the Timer icon will ﬂash. Press any button stop the alarm/light.

Timer 1 and Timer 2 can be used as count-up timers starting from zero. Press START/STOP to start counting up. Press again to pause and resume the count up. The total count-up time is 23 hours, 59 minutes, and 59 seconds. After the total count-up time is reached, the timer will return back to zero and restart the count up.
To clear the time back to zero, press HOUR and MIN simultaneously.
To view other modes while counting up, press MODE to enter the Alarm Clock or Clock modes. “COUNT-UP” will ﬂash on the display to show the timer is still counting up.

• To Program Alarm Clock:

Press HOUR, MIN, and/or SEC to set the desired time. Press and hold each button for fast advance.
Press START/STOP to save. The colon will begin ﬂashing.
When the clock reaches the desired time set, the alarm will sound or the light will ﬂash. “TIMES UP” and the clock icon will ﬂash on the display. Press any button to stop the alarm/light. The alarm/light will automatically turn off after 1 minute, but the “TIMES UP” and clock icon will continue to ﬂash until any button is pressed.