Shenzhen SL2008 LMP keyboard protect case ipad User Manual
- June 5, 2024
- Shenzhen
Table of Contents
LMP Keyboard ProtectCase for iPad 10.2″
Quick Start Guide
Multifunctional Keys
LED Status Indicators
Caps Lock indicator:| Light on means uppercase letters; light off means
lowercase letters
---|---
Wireless status:| Press „Fn+C” to perform the pairing between iPad and
keyboard. The LED will turn off when the connection to the iPad has been
successfully established.
Battery status:| A flashing light indicates a low battery level. Constant
light means charging. Green light means fully charged.
Keyboard Pairing
- Switch on the iPad, then pair the Bluetooth keyboard.
- Move the on/off switch to the ON position, then press „Fn+C” to perform the pairing. The LED will turn off when the connection to the iPad has been successfully established. If the connection has not been established within 3 minutes you need to repeat the pairing process from the start.
- Select „Settings” ⇒ „Bluetooth”. Make sure that Bluetooth is turned on.
- Select under „OTHER DEVICES” the „LMP BT Keyboard”.
- A 4-digit numeric code is displayed on the screen. Type in the numbers on the keyboard and press „Enter” on the keyboard to confirm.
- The pairing has been successful when „LMP BT Keyboard” is listed under „MY DEVICES” in the Bluetooth settings.
- In case the pairing has failed, repeat the pairing process from 2.
Connection Problems
- Make sure the keyboard is turned on and the battery is charged.
- Make sure the keyboard is close to the iPad.
- Make sure that Bluetooth is enabled on the iPad.
- Make sure the keyboard has been paired with the iPad.
Maintenance
- Keep the keyboard away from liquids and magnetic fields.
- Use a soft cloth to clean the keyboard.
- When not in use, switch off the keyboard.
Mounting the Stand
| |
---|---|---
1. Pull the magnetic flap backward. Push the center of the stand outwards.|
2. Put the magnetic flap over the stand holder.| 3. The stand is now firmly
locked.
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. Suppose this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on. In that case, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
LMP v2.2, 2/2020
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>