Cobra SC200 Dash cameras User Manual
- June 5, 2024
- Cobra
Table of Contents
SC SERIES Dash Cameras
Important Product Information
Important Safety Information
Safe Driving
Motorists, as well as operators of emergency or service vehicles, are
expected to exercise all due caution while using this product and to obey all
applicable traffic laws.
Security of Your Vehicle
Before leaving your vehicle, always remembers to conceal this device in
order to reduce the possibility of break-in and theft.
Privacy
This device may not be used to violate the privacy rights of others. In no
way will Cobra Electronics or its subsidiaries be responsible for the
inappropriate use of this product. It is the sole responsibility of the buyer
to consult legal counsel for the interpretation of any laws applicable to the
area of the intended use of this product.
Forward Collision Warning System
Warming The forward collision warning system (FCWS) feature, when turned on,
is for informational purposes only. The FCWS does NOT replace a driver’s
responsibility to use safe driving judgment, comply with all traffic
regulations, and observe all road and driving conditions at all times. The
FCWS uses the camera to provide a warning of upcoming vehicles landing large
objects) and, as a result, may have limited functionality in low visibility or
certain weather conditions.
Lane Departure Warning System
Warning! The Lane Departure Warning System (LDWS) feature, when turned on, is
for informational purposes only. The LDWS does NOT replace a driver’s
responsibility to use safe driving judgment, comply with all traffic
regulations, and observe all road and driving conditions at all times. The
LDWS uses the camera to provide determine if the vehicle is drifting toward or
departing from designated lane markings and, as a result, may have limited
functionality in low visibility or certain weather conditions or when driving
on unmarked or poorly marked roads.
Regulatory Information
NOTE: This device complies with part 15 of FCC rules: Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on. In
that case, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Modifications or parts not approved by Cobra Electronics
Corporation may violate FCC Rules and void authority to operate this
equipment.
This device complies with RSS-247of Industry Canada. Operation is subject to
the condition that this device does not cause harmful interference.
RF Exposure
FCC RF Radiation Exposure Statement:
- This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
- This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
- This equipment should be installed and operated with a minimum distance of 20cm between the device & your body.
The device has been tested and complies with SAR limits, users can obtain Canadian information on RF exposure and compliance.
Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Industry Canada ICES-003 Compliance: CAN ICES-3 (B)/NMB-3(B)
Disposal of Old Electrical or Electronic Equipment
This product may contain hazardous substances that could impact health and the
environment if not disposed of properly.
The crossed-out wheeled bin symbol indicates that the product should not be
disposed of along with the household waste. It should be handed over to an
applicable collection point for the recycling of electrical equipment. By
ensuring that this product is disposed of correctly you will help/prevent
potential negative impacts on the environment.
If you need more information on the collection, reuse, and recycling systems,
please contact your local civic office or the shop where it was originally
purchased.
Limited One-Year Warranty
Cobra Electronics Corporation warrants that this product and the component
parts thereof will be free of defects in workmanship and materials for a
period of one year from the date of first consumer purchase. This warranty may
be enforced by the first consumer purchaser. If the product is under warranty,
it will be repaired or exchanged depending on the model as determined at
Cobra’s sole discretion. Such remedy shall be your sole and exclusive remedy
for any breach of warranty.
The procedure for obtaining service and support, and the applicability of this
warranty, will vary depending on the country or jurisdiction in which you
purchased and utilize the product. For the details on obtaining product
service, support and warranty please visit
www.cobra.com/support
Provided that the product is utilized within the U.S.A.- Cobra will, without
charge, repair or replace, at its option, defective products, products, or
component parts upon delivery to the Cobra Factory Service department,
accompanied by proof of the date of first consumer purchase, such as a
duplicated copy of a sales receipt.
You must pay any initial shipping charges required to ship the product for
warranty service, but the return charges, to an address in the U.S.A., will be
at Cobra’s expense, if the product is repaired or replaced under warranty.
This warranty gives you specific legal rights, and you may also have other
rights which may vary from state to state and country to country.
Proof of Purchase Required:
Please check your owner’s manual for warranty specifics and product service
details. For warranty service, you will need to provide proof of purchase from
an approved retailer. Please note that if you purchased your product on eBay,
Amazon, or other 3rd party internet marketplaces, you will need to provide a
receipt from the actual seller for verification as an approved retailer.
Exclusions: This limited warranty does not apply: 1) To any product
damaged by accident; 2) In the event of misuse, ordinary wear, failure to
follow directions or improper maintenance of the product or as a result of
unauthorized alterations or repairs; 3) If the serial number has been altered,
defaced, or removed; 4) If the product was purchased or is utilized in a
jurisdiction not covered by the limited warranty. All implied warranties,
including warranties of merchantability and fitness for a particular purpose,
are limited in duration to the length of this warranty.
Cobra shall not be liable for any incidental, consequential or other damages;
including, without limitation, damages resulting from loss of use or cost of
installation.
Some states and countries do not allow limitations on how long an implied
warranty lasts and/or do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitations may not apply to you. This
warranty gives you specific legal rights, and you may also have other rights
which vary from state to state and country to country
Product Service and Support
For any questions about operating or installing this new Cobra product,
PLEASE CONTACT COBRA FIRST...do not return this product to the retail
store. The contact information for Cobra will vary depending on the country in
which you purchased and utilize the product. For the latest contact
information, please go to
www.cobra.com/support
For products purchased in the U.S.A., you may call
1-800-262-7212 (1-800-COBRA-12).
For products purchased in Europe, you may call 0333 121 2252 or visit
www.snooperneo.co.uk.
For Products Purchased in the U.S.A., if your product should require factory
service, please go to www.cobra.com/support
and follow the instructions for returning your product to the Cobra Factory
Service Department for service
Should there be any problems with this product or further information needed
on its features please visit www.cobra.com for
support, frequently asked questions, Declarations of Conformity, and the full
product manual.
The product label is located on the unit.
For Products Containing Internal Batteries
An attempt to open the device and remove/replace the battery could result in
damage to the device or battery and result in a voided warranty. Batteries
should not be exposed to excessive heat such as sunshine, fire, or the like.
Trademarks
©2020 Cobra Electronics Corporation, 6500 West Cortland Street, Chicago,
Illinois 60707 U.S.A.
Cobra and the snake design are proprietary trademarks of Cobra Electronics
Corporation, USA.
The Bluetooth® word mark is a registered trademark owned by Bluetooth SIG,
Inc. and any use of such marks by Cobra Electronics Corporation is under
license. Other trademarks and trade names are those of their respective
owners.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>