Nokia 2.4 Li-Po 4500 mAh Smartphone User Manual
- June 5, 2024
- Nokia
Table of Contents
Nokia 2.4 Li-Po 4500 mAh Smartphone
Get Started
*Google Assistant is not available in certain languages and countries. Where not available, Google Assistant is replaced by Google Search. Check availability at https://support.google.com/assistant.
Insert the SIM and memory card
-
Open the SIM card tray: push the tray opener pin in the tray hole and slide the tray out.
-
Put the nano-SIM in the SIM slot on the tray with the contact area face down.
-
If you have a dual-SIM phone, put the second SIM in the SIM2 slot.
Tip: To find out if your phone can use 2 SIM cards, see the label on the sales box. If there are 2 IMEI codes on the label, you have a dual-SIM phone. -
If you have a memory card, put it in the memory card slot.
-
Slide the tray back in.
Use only original nano-SIM cards. Use of incompatible SIM cards may damage the
card or the device, and may corrupt data stored on the card.
Use only compatible memory cards approved for use with this device.
Incompatible cards may damage the card and the device and corrupt data stored
on the card.
Important: Do not remove the memory card when an app is using it. Doing so may
damage the memory card and the device and corrupt data stored on the card.
Both SIM cards are available at the same time when the device is not being
used, but while one SIM card is active, for example, making a call, the other
may be unavailable. 
2. Charge the battery and switch the phone on
Plug a compatible charger into a wall outlet, and connect the cable to your
phone. Your phone supports the USB micro-B cable. You can also charge your
phone from a computer with a USB cable, but it may take a longer time.
If the battery is completely discharged, it may take several minutes before
the charging indicator is displayed.
To switch your phone on, press and hold the power key until the phone
vibrates. The phone guides you through the setup.
For an online user guide and troubleshooting help, go to www.nokia.com /mobile-support.
Product and safety info
Important: For important info on the safe use of your device and battery,
read the Product and safety info booklet before you take your device into use.
You can only use your device on the GSM 850, 900, 1800, 1900; WCDMA 1, 5, 8;
LTE 1, 3, 5, 7, 8, 20, 28, 38, 40, 41 networks.
You need a subscription with a service provider.
Important: 4G/LTE might not be supported by your network service provider
or by the service provider you are using when traveling. In these cases, you
may not be able to make or receive calls, send or receive messages or use
mobile data connections. To make sure your device works seamlessly when full
4G/LTE service is not available, it is recommended that you change the highest
connection speed from 4G to 3G. To do this, on the home screen, tap Settings >
Network & Internet > Mobile network > Advanced, and switch Preferred network
type to 3G.
For more info, contact your network service provider.
Maximum transmit power
| GSM 850, 900 | 35 dBm |
|---|---|
| GSM 1800, 1900 | 32 dBm |
| WCDMA 1, 5, 8 | 25 dBm |
LTE 1, 3, 5, 7, 8, 20,
28, 38, 40, 41
| 25 dBm
Bluetooth®| 7.5 dBm
WLAN 2.4G| 18 dBm
Your device has an internal, non-removable, rechargeable battery. Do not
attempt to remove the battery or back cover, as you may damage the device. To
replace the battery, take the device to the nearest authorised service
facility.
Charge your device with the CH-35E (EU plug) / CH-35X (UK plug) / CH-35N
(India plug) / CH-35U (US plug) / CH-35A (Australia plug) / CH-51E (Indonesia
plug) / CH-51B (Brazil plug) chargers. HMD Global may make additional battery
or charger models available for this device. Charging time can vary depending
on device capability. Some of the accessories mentioned in this user guide,
such as charger, headset, or data cable, may be sold separately.
The surface of the device is nickel-free.
Parts of the device are magnetic. Metallic materials may be attracted to the
device. Do not place credit cards or other magnetic stripe cards near the
device for extended periods of time, since the cards may be damaged.
Note: Pre-installed system software and apps use a significant part of
memory space.Keep a safe distance when using the flash. Do not use the flash
on people or animals at close range. Do not cover the flash while taking a
photo.
Certification information (SAR)
This mobile device meets guidelines for exposure to radio waves as set forth by the Council of Europe (CE). Refer to the following.
European RF Exposure Information
Your mobile device is a radio transmitter and receiver. It is designed not to
exceed the limits for exposure to radio waves recommended by international
guidelines. These guidelines were developed by the independent scientific
organization ICNIRP and include safety margins designed to assure the
protection of all persons, regardless of age and health. The guidelines use a
unit of measurement known as the Specific Absorption Rate, or SAR.
The SAR limit for mobile devices is 2.0 W/kg and the highest SAR value for
this device when tested at the ear is 0.27 W/kg. As mobile devices offer a
range of functions, they can be used in other positions, such as on the body.
In this case, the highest tested SAR value is 1.54 W/kg at the separation
distance of 0.5 cm from the body.
For electronic safety, maintain the separation distance with accessories
containing no metal, that position handset a minimum of the above distance.
Use of other accessories may not ensure compliance with RF exposure
guidelines.
*The tests are carried out in accordance with international guidelines for testing.
This mobile device meets guidelines for exposure to radio waves as set forth
by the Federal Communications Commission (FCC). Refer to the following.
FCC RF Exposure Information
Your handset is a radio transmitter and receiver. It is designed and
manufactured not to exceed the emission limits for exposure to radio frequency
(RF) energy set by the Federal Communications Commission of the U.S.
Government. The guidelines are based on standards that were developed by
independent scientific organization through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons, regardless of age and health.
The exposure standard for wireless handsets employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6 W/kg. The tests are performed in positions and locations (e.g. at the ear
and worn on the body) as required by the FCC for each model. The highest SAR
value for this handset model as reported to the FCC when tested for use at the
ear is 0.52 W/kg (TA-1270), 0.67 W/kg (TA-1275), and when worn on the body in
a holder or carry case, is 1.21 W/kg (TA-1270), 1.14 W/kg (TA-1275).
Body-worn Operation; This device was tested for typical body-worn operations
with the handset kept 1.0 cm from the body. To maintain compliance with FCC RF
exposure requirements, use accessories that maintain a 1.0 cm separation
distance between the user’s body and the handset. The use of belt clips,
holsters and similar accessories should not contain metallic components in its
assembly. The use of accessories that do not satisfy these requirements may
not comply with FCC RF exposure requirements, and should be avoided. The FCC
has granted an Equipment Authorization for this handset model with all
reported SAR levels evaluated as in compliance with the FCC RF emission
guidelines. SAR information on this handset model is on file with the FCC and
can be found under the FCC ID Search section of
www.fcc.gov/oet/ea/ after searching on FCC ID
2AJOTTA-1270 and 2AJOTTA-1275.
Additional information on Specific Absorption Rates (SAR) can be found on the
FCC website at www.fcc.gov/general/radio-frequency-
safety-0.
To send data or messages, a good connection to the network is needed. Sending
may be delayed until such a connection is available. Follow the separation
distance instructions until the sending is finished.
During general use, the SAR values are usually well below the values stated
above. This is because, for purposes of system efficiency and to minimise
interference on the network, the operating power of your mobile is
automatically decreased when full power is not needed for the call. The lower
the power output, the lower the SAR value.
Device models may have different versions and more than one value. Component
and design changes may occur over time and some changes could affect SAR
values.
For more info, go to www.sar-tick.com. Note that
mobile devices may be transmitting even if you are not making a voice call.
Your mobile device is also designed to meet the United States Federal
Communications Commission (FCC) guidelines. FCC ratings for your device and
more information on SAR can be found at
http://transition.fcc.gov/oet/rfsafety/sar.html.
The World Health Organization (WHO) has stated that current scientific
information does not indicate the need for any special precautions when using
mobile devices. If you are interested in reducing your exposure, they
recommend you limit your usage or use a hands-free kit to keep the device away
from your head and body. For more information and explanations and discussions
on RF exposure, go to the WHO website at www.who.int/peh-
emf/en.
Copyrights and other notices
EU Declaration of Conformity
Hereby, HMD Global Oy declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. A copy of the EU Declaration of Conformity can be found at https://www.nokia.com/en_int/phones/declaration-of-conformity.
FCC notice:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. For more info, go
to www.fcc.gov/engineering-technology/electromagnetic-compatibility-division
/radio-frequency-safety/faq/rf-safety. Any changes or modifications not expressly approved by HMD Global
could void the user’s authority to operate this equipment. Note: This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device has an electronic label for certification information. To access
it, select Settings > System > Certification.
© 2020 HMD Global. HMD Global Oy is the exclusive licensee of the Nokia brand
for phones & tablets. Nokia is a registered trademark of Nokia Corporation.
Android, Google and other related marks and logos are trademarks of Google
LLC.
The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any
use of such marks by HMD Global is under license.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>