Kelung KLXX000X WLAN IP Extender User Manual
- June 5, 2024
- Kelung
Table of Contents
Kelung KLXX000X WLAN IP Extender
Turn on electricity after Wlan IP extender connects with antenna. Should be
aligned the transmitting antenna with the receiving antenna and not deviate
from each other.
WLAN IP extender connects with antenna to transfer signal automatically. The
installer can use their own device through RJ45 cable. The WLAN IP extender
use DC12v power which passes the FCC certification.
The manufacturer will set the channel in default mode, but installers can set the channel themselves according to the environment.
- The antenna installation position is according to the control center.
- The RX box should install near the control center.
- The Transmitter and Receiver box are the same units.
- The manufacturer will setup in TX or RX mode and it would label it.
- So the installer will know the installation process.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device must not cause harmful interference, and
- This device must be able to withstand any interference received, including interference that may cause undesired operation.
FCCWarning
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorienting or relocating the receiving antenna.
- Increasing the distance between the equipment and the receiver.
- Connecting the equipment to a different outlet from that to which the receiver is connected.
- Consulting the dealer or an experienced technician for help.
Caution:
To comply with the limits for an FCC Class B computing device, always use the
shielded signal cord supplied with this unit. The Federal Communications
Commission warns that changes or modifications to the unit not expressly
approved by the party responsible for compliance could invalidate the user’s
authority to operate the equipment.
FCC RF Radiation Exposure
This equipment complies with the FCC RF radiation exposure limits stipulated
for an uncontrolled environment. This device and its antenna must not be co-
located or operated in conjunction with any other antennas or transmitters. To
comply with FCC RF exposure compliance requirements, the antenna used for this
transmitter must be installed so as to provide a separation distance of at
least 20 cm from all persons and must not be co-located or operated in
conjunction with any other antennas or transmitters.
Professional installation instruction
Installation personal
This product is designed for specific applications and needs to be installed
by a qualified person who has RF and related rule knowledge. The general user
shall not attempt to install or change the setting.
Installation location
The product shall be installed at a location where the radiating antenna can
be kept 40cm from a nearby person in normal operating conditions to meet
regulatory RF exposure requirements.
External antenna
Use only the antennas which have been approved by the applicant. The non-
approved antenna(s) may produce unwanted spurious or excessive RF transmitting
power which may lead to the violation of FCC/IC limit and is prohibited.
Installation procedure
Please refer to user’s manual for the detail.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>