Honeywell RC7189WS1000 Wireless Room Sensors Classic Thermostats User Manual

: June 5, 2024
: Honeywell

Table of Contents

Honeywell RC7189WS1000 Wireless Room Sensors Classic Thermostats
INTRODUCTION
Placement Tips
FCC Regulations
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Honeywell RC7189WS1000 Wireless Room Sensors Classic Thermostats

INTRODUCTION

Getting Started

Read before installing.
To link the sensor to the thermostat please follow the steps below on the thermostat. Honeywell RC7189WS1000 Wireless Room Sensors Classic Thermostats
FIG 1

Open the Menu
Tap “Devices & Sensors”
Tap “Add”
Follow the on-screen instructions

Placement Tips

DO place about 5 feet above the ﬂoor.
DO place on inside walls.
DON’T place behind furniture or doors.
DON’T place in direct sunlight.
DON’T place above air vents.

The operation of this equipment is subject to the following two conditions: (1) this equipment or device may not cause harmful interference, and (2) this equipment or device must accept any interference, including interference that may cause undesired operation.

FCC Regulations

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
(15B)This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Information
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled enviroment.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter and must be installed to provide a separation distance of at least 20cm from all persons.