SHENZHEN M3-5-15W Car Wireless Charging Pad Instruction Manual
- June 5, 2024
- Shenzhen
Table of Contents
Package Content
- Wireless Charging Pad
- USB Splitters
- Micro USB Cables
Installation Instructions
Plug the two Micro USB cables into the ports at the back of the charger.
Remove C1) the black protection bar, the original Tesla pad, and CS) the two charging cables.
Connect the charger to the front USB ports.
Place the wireless charger and put back the black protection bar.
USB Splitters Instruction
Please connect the wireless charger to the power—only cables (the smaller
cables) of the USB splitters, not the power+data cables.
More accessories just for Tesla Model 3 are available now: Seat Covers,
Spoiler, Cup Holder and Center Console Liners, Wheel Bands Kit, Sunshades,
Phone Holder, All-Weather Interior Mats, Integrated Key Holder, Wheel Center
Caps Pedal Covers, Screen Protector, Carbon Fiber Decal, LED Puddle Lights,
Trunk Mats, Key Card Holder, etc.
FCC ID: 2AS5P-TM3-05-15W
FCC WARNING:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’ s RF Exposure guidelines, This equipment should be installed and operated with a minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>