matrix decor BLF-T05 Evaporative Air Cooler User Guide

June 5, 2024
matrix decor

matrix decor BLF-T05 Evaporative Air Cooler

SAFETY INSTRUCTIONS

For your safety concerns, please make sure to follow the instructions above.

  1.  This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  2.  Children should be supervised to ensure that they do not play with the appliance.
  3.  Before any maintenance, make sure the machine is in the “off state, and the power is switched off. In order to avoid the electric shock, please connect the grounding socket correctly, and guarantee the connection of the grounding device with the function of automatic protection from faults.
  4.  If the supply cord is damaged, it must be replaced by manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
  5.  Ensure that the fan is switched off from the supply mains before removing the guard.
  6. Unplug the appliance during filing and cleaning.
  7. Do not use any corrosive or solvent detergent for cleaning. It is recommended to use wet cloth to wipe the machine instead of flushing the machine. Please avoid the machine exposed to direct sunlight.
  8.  It is strictly prohibited to use this machine in a circumstance with inflammable or explosive gas.

WORKING PRINCIPLE

  1.  The draught fan does a suction to make a subpressure, at the same time the pump carries the water to the distribution instrument to make the wet curtain moist.
  2. The hot air passes through the wet curtain, and the heat is absorbed by the evaporating water, then the temperature comes down.
  3.  The cool air is blown out by the fan. The unevaporated water would drop to the water tank and form a circulation.

ATTENTION

Please open the window and the door when you are using this machine. To keep fresh air circulating smoothly, the best way is to place it in front of the ventilation coridors.

PARTS& ACCESSORIES

matrix-decor-BLF-T05-Evaporative-Air-Cooler-fig1

SPECIFICATIONS

OPERATING INSTRUCTIONS

Filling Water:
As shown in figure 1, the first way, pull out the tank from the back of the machine,filling water until the highest water level.
As shown in figure2, the second way, open up cover plate, filling slowly with clean water.
Attention: Please do not exceed the maximum water level of the water tank.

matrix-decor-BLF-T05-Evaporative-Air-Cooler-fig2

The Usage of lce-box

  1. If you use ice box for the first time: open the lid, inject water up to the scale, then tighten the lid.
  2. Set aside for 30-40minutes, till the water and ice crystal mix completely
  3. Put the icebox in the refrigerator’s freezer room to stay for two hours.
  4. Take the icebox out and put it into the air cooler’s ice container in order to cool down the water temperature.
  5.  After using it for a long time, the ice crystal turns to jelly, please put it in the refrigerator again. It can be recycled and reused.

Empty the Water Tank
The drain outlet is on the bottom, as shown in Figure 3. Loose the drain nut, and tilt the machine body, the water tank can be completely emptied. The machine should be regularly drained and cleaned. If it will not be used for a long time, please empty the water tank.

CONTROL PANEL

matrix-decor-BLF-T05-Evaporative-Air-Cooler-fig4 matrix-decor-BLF-T05-Evaporative-Air-Cooler-fig15

REMOTE CONTROL

  • ON/OFF:
    Press this button to open the air cooler
    Press this button at any state to stop the operation.

  • SPEED
    Press to change the wind speed into Small / Middle / High.

  • SWING
    Press to control the left-right swing; Press again to stop Swinging.

  • TIMER
    Press to set timing system. The timer range is from 1h-7h.

  • COOLING
    Press to open or close the cooling system.

  • MODE
    Press to change the wind type into Natural / Sleeping Normal Mode.

The remote control uses on button cell battery, type CR2025(3V). To remove the battery carriage use your thumb to squeeze the release tab to the right and then pull the carriage out. Place the battery into the carriage and slide the carriage back into the remote.

NOTE:
Follow battery disposal instruction on battery packaging, or contact your local safety council for safely disposal of batteries.

CLEANING/ MAINTENANCE INSTRUCTIONS

Warm prompt
After long-time operation, dust accumulation on the pre-flters and the wet curtain would affect the airflow and air purify. Please clean the machine regularly.

  1. Clean pre-filter
    Tum off the power, loose the screws, then pull out the pre-filter, clean it with soft brush and mild detergent, rinse by water and dry under the sunshine.

  2. Clean wet curtain
    Turn off the power, loose the screws in the back-cover plate, take out the back-cover plate. Loose the plastic nuts on the wet curtain, the side of wet pad can be emoved. clean it with soft brush and mild detegent, rinse by water and dry under the sunshine, then install back to the machine.lf the dirt is hard to remove after long-term usage, please change a new wet curtain.

  3. Clean the surface
    Turn off the power, clean it with mild detergent and soft cloth. Notice: control panel shall not be touched by water.

FAULT AND MAINTENANCE

matrix-decor-BLF-T05-Evaporative-Air-Cooler-
fig8 matrix-decor-BLF-T05-Evaporative-Air-
Cooler-fig9

STORAGE

Store the air cooler in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals