Shenzhen Dsenbor Technology T590 Wireless Charging and USB Output User Manual
- June 5, 2024
- Shenzhen Dsenbor Technology
Table of Contents
Parameters
| Input | 12V-1,5A |
|---|---|
| Wireless-Charging Output | lOW (Max) |
USB-C
USB-C Output
| 5V-2.4A (Max)
Charging Distance| 15-30 mm
Attention:
Wireless charging and USB output cannot be used simultaneously.
Installation
1)233M 1) Magnetic Conductive Desktop Paster; 2) Locator; 3) 3M Glue
-
30mm
-
Please ensure that the desktop is made of non-metallic material with a thickness not exceeding 30 mm.
-
Connect the adapter:
please connect the attached adapter to energize the wireless charger. -
Paste magnetic conductive desktop paster: paste magnetic conductive desktop paster at any position on the desktop; ensure that there is no iron crossbeam under the table.
-
Align locator: place the locator in the center of the desktop paster. 3M,
-
Paste the wireless charger: tear off the paster of 3M glue on the wireless charger, align the wireless charger with the locator on the desktop, and paste the wireless charger under the table when all the lights the locator are on.
-
Put the mobile phone on the desktop and it is ready to use if the charging state is displayed.
-
Attention
-
Do not disassemble the device without permission.
The charging distance applicable to the charger is 15-30 mm. Do not place the mobile phone directly on the charger, which will trigger the foreign object detection function of the charger. -
*Do not place metal sundries or magnetic cards on the wireless charging desktop, which may result in damage or the charger not operating.
If the charging is suspended due to overheating of the transmitter or changing device when using, please remove the charging device and recharge after cooling.
Make sure your device supports Qi wireless charging protocol or is installed with Qi compliant wireless receiver (non-inclusive).
Do not use or store the wireless charger under the condition of high temperature or humidity.
** State of Indicator- 1S · Power on–the red and green indicators flash for 1s and then turn off.
- Standby mode–green indicator is always on.
- ·Charging–red indicator is always on.
- Fully charged–if the charging device sends out the charging completion signal after full charge, the green indicator will be always on.
FOOD
- FOD foreign object detection–the red indicator flashes all the time.
Quality Assurance
- 24-month warranty Lifelong technical support
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum distance of 20cm from the radiator of your body: Use only the supplied antenna.