KEDING K268269 Pop Up Socket Instruction Manual
- June 5, 2024
- KEDING
Table of Contents
KEDING
K268269 Pop-Up Socket
Instruction Manual
Pop Up Socket
CUTOUT AND MOUNTING STEPS:
- Select the desired location of a countertop or desktop, if used on a countertop need to be at least 10? from stovetop or other heating sources
- The selected location must be at least 0.79 inches (20mm) away from the edge of the cou nt ert op or similar surface.
- The mounting surface must be between 0.39 inch (10mm) and 1.77 inches (45mm) thick.
Installation Instructions:
-
Layblue painter’s tape on lie surface on the wood.
-
Mark the positions of the hole and drill through the tape into the wood. Painter’stape is a better choice than all-purpose tan tape because it adheres less strongly and is easMo pull off.
-
Cuthole in the surface of the countertop of 4)4.0 inch
-
Feel the power cord through the hole through countertop first, followed by the main unit, pushing down until gasket rests on the countertop.
-
Feed power cord through locking flange and thread flange counterclockwise until locked in place again g underside of
countertop. -
To open the pop-up feature, press firmly on the cover. Un it will deploy upward app proximately 1? initially, then pull cover upward until unit locks into place. T °close device, push the plastic locking tab, and push down on the cover until unlocks.
Product description
Specification
| S.N | Name | Details |
|---|---|---|
| 1 | Wireless charger | Output: 10W max(or customize) |
| 2 | USB charger | Output DC 5V 3.4A(two ports together), 17W(max) |
| 3 | LED light | Power: 1.2W(max), dimmable, color temp 2500K |
| 4 | Power socket | As per the type of power socket |
| 5 | LED switch | Touch the switch, and adjust the light brightness by pressing |
and holding
6| Overload Pm(edi°11 switch| 15A /125V, reset off
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful inter(
erence in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>