LOGISYS JM-RM01 Remote Controller User Manual
- June 5, 2024
- LOGISYS
Table of Contents
LOGISYS JM-RM01 Remote Controller
INTRODUCTION
Areas of application
- Remote control switch
- alarm systems, , remote control door locks, remote control electric shutter doors and Windows, water pump control, industrial control products, etc.; technical parameters:
- Working voltage: DC6V
- Working frequency: 433.92 MHz
- Standby current: 0MA
- Working current: > 20MA
- Encoding Type: fixed code (2264) and learning code (EV1527)
- Transmission distance: > 30 m (open area sensitivity more than 103 dBm)
- Output power: 30 m (0 DBM);
- Transfer rate: < 10 KBPS
- Modulation mode: ASK (amplitude modulation)
- Working temperature: – 10 ℃ ~ + 70 ℃
- Size:30 60 12 mm
Tips :
- This series of remote wireless remote control with 1/2/3/4key optional;
- With the power switch, remote control can turn off the power save electricity when not in use. Federal Communications Commission Notice
FCC Rules
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two co nditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance co uld void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable p rotection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the inst
ructions, may cause harmful interference to radio communications. However,
there is no guarante e that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment of f
and on, the user is encouraged to try to correct the interference by one or
more of the followin g measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is con nected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in p ortable exposure condition without restriction.