LOGISYS RMT-01 Wireless Remote Instructions
- June 13, 2024
- LOGISYS
Table of Contents
LOGISYS RMT-01 Wireless Remote
Product Information
The RMT-01 is a remote control device designed for unlocking and locking doors. It operates at a quiescent current of 3uA and anoscillation resistance of 9.84375MHz.
Product Usage Instructions
- Start by matching the key with the door.
- To unlock the door, press and hold the “Unlock” key for 2 seconds.
- To lock the door, press and hold the “Lock” key for 2 seconds.
- The “Auto mode” can be activated by pressing the “Auto mode” key.
- Make sure to keep the remote control within range of the door for proper functioning.
Model number： LU-RMT01
Specification
- IC model： HS1527
- Working voltage ：12V
- Wordking current： 8~12mA
- Emission frequency： 315MHz(±100K)
- Emission power： ≥10MW
- Modulation system ：ASK
- Transmission distance： 20-50meter
- Quiescent current： ≤3uA
- Oscillation resistance： 9.84375MHz
- After matching the key with the door, press the 2-second unlocking key to open the door, and press the 2-second locking key to close the door.
FCC STATEMENTS
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- This device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement.