Zgonic North America 300215 Zview Wireless Charger Instruction Manual
- June 5, 2024
- Zgonic North America
Table of Contents
Zgonic North America 300215 Zview Wireless Charger Instruction Manual
SPECIFICATIONS
Wireless Charger
- Input: 5V 3A/9V 2.22A/12V/1.67A
- Charging Mode : 15W
- Dimensions: φ62 x 10.6mm
Type-C Power Cable
- Type-c to Type-c – 1.8 meter
PD + QC 3.0 Adapter
- Input: 100-240V,50/60Hz,0.8A
- Output: 5V 3A/9V 2.22A/12V/1.67A
SAFETY PRECAUTIONS
- Use only certified power adapter as provided, non-certified power adapter may cause irregular or no charging.
- Do not use products provided for anything other than its intended use.
- Use product in location with temperature of 32°F(0°C) – 95°F (35°C), avoid heat source and direct sunlight.
- Avoid water contact or any other liquid. If product becomes wet, unplug it from power source immediately.
- Do not use product if dropped or damaged in any way.
- Any repairs to products should be performed by a qualified electrician only.
- Do not place magnetic cards or similar items near the product.
- Use specified power source and voltage only.
- Place charger on a flat and sturdy surface during use.
- Keep product out of reach of children.
Charging Instruction
FCC WARNING STATEMENT
The two-part warning label described in FCC 15.19(a)(3), “This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.”
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be colocated or operating in conjunction with any other antenna or transmitter. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
ISED Canada Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada ‘s licence-exempt RSS(s). Operation is subject to the following two conditions
- this device may not cause interference and
- this device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure : This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment
RF Exposure Statement
To maintain compliance with IC’s RF Exposure guidelines, This equipment should be.installed and operated with minimum distance of 10cm the radiator your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.