IKEA 904.303.69 BETTORP LED Mobile Lamp with Wireless Charging Instruction Manual

IKEA 904.303.69 BETTORP LED Mobile Lamp with Wireless Charging Instruction Manual

Features

• Wirelessly rechargeable lamp.
• Certified according to specification Qi 1.2.4 BPP.
• 3 levels of dimming: 150lm/60lm/18lm.
• LED status indicator.

Instructions for use

This lamp can be recharged by a wireless charger. After being fully charged, it can be turned on for up to 6 hours.
Before using the lamp for the first time, remove the outer base cover and remove the battery box lid.
Insert 4 x 1.2V AA/HR6 NiMH batteries (not included) with correct polarity.
Close the lid and put back the outer cover on the lamp base.
Attach the shade at the top.
The lamp is now ready for use.

Charging

• Charging For wireless charging, place the device to be charged on top of the plus sign (+) on the charger. The device must be placed directly over the plus sign (+) on the charger for the charging function to work optimally.
• If your battery is completely discharged, it may take a few minutes before it starts charging. This is entirely normal.
• The LED charging indicator on the lamp will alternate between flashing red and green in case of wrong battery types or incorrect polarity.

LED charging indicator:

• Charging: constant LED red light.
• Charging
  • completed: constant LED green light.
  • Error: LED flashes red and green.

Good to know

• Devices may get warm during charging. This is completely normal, and they will gradually cool down again after they are fully charged.
• Charging time may vary based on the device’s battery capacity, charge level, the age of the battery and the temperature in the surrounding area.
• Storage temperature: -20°C to 25°C (-4°F to 77°F).
• Operating temperature: 0°C to 40°C (32˚F to 104˚F).

Care instructions

To clean the product, wipe with a soft cloth moistened with a little mild detergent. Use another soft dry cloth to wipe it dry.

Note!
Never use abrasive cleaners or chemical solvents since this can damage the product.
Save these instructions for future use.

WARNING:

• Only use the product in dry locations.
• Children should be supervised to ensure they do not play with the product.
• Do not subject the product to wet, moist or excessively dusty environments since this can cause damage to the unit.
• If the product is damaged, it should be disposed of.
• Only to be used with Qi-certified chargers.

Recommended battery types:

4 x IKEA LADDA 2450 (AA/HR6, 1.2V, 2450mAh, Ni-MH) (not included).
Use only Ni-MH type batteries.
Do not use Alkaline, Carbon Zink or other similar battery types.
Do not mix batteries of different capacities, types or date stamps.
Remove the batteries if the product is to be stored for a long time or before it is scrapped.

Product servicing

Do not attempt to repair this product yourself. If you open or remove parts, you may expose yourself to dangerous voltage points or other risks.

Technical data

Type: E2022 BETTORP
Input: 5.0V DC/4 x 1.2V AA/HR6 Ni-MH
Estimated charging   time: 4-5 h
Estimated battery time: 6 h at 100% brightness
Brightness: 150lm/60lm/18lm

Indoor use only
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN

The ‘Qi’ symbol is a trademark of the Wireless Power Consortium

This device complies with Part 15 of the FCC Rules.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation Science and Economic Development Canada’s licence-exempt RSS standard(s).

Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation of the device.

WARNING:
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>