Shenzhen E Lover Technology EL-ROL-1 LED Rock Light Instruction Manual
- June 5, 2024
- Shenzhen E Lover Technology
Table of Contents
Shenzhen E Lover Technology EL-ROL-1 LED Rock Light
APP Introduction
Welcome to smart life. Just 3 steps to connect the light kit with the mobile, are you ready.
Download the APP
- Scan the QR code or search in APP STORE or GOOLE PLAY to download the app named: Smart life.
Log in the APP
- Log in or sign up to the APP and start your color journey. If you don’t have an account, you can use TRY NOW without log in.
Auto-connect
- Now for the last step,add the device to the mobile. Click ‘add device’ and select ‘auto scan’, then turn on the Light Kit, it will auto-connect to your mobile, and click ‘Done’ to start your customized smart life.
( Note: when you turn on the light kit you will see the red light flashing, this means that the light kit is ready to connect to the mobile, this will last for 3 minutes, if you do not succeed in connecting within this 3 minutes, just restart the light kit until the red light flashes)
Remote Control Introduction
Specification
Lights Installation
- Step1: Fix With Screws.
- Step2: Connect the cables.
- Step3: Power Connection
Trouble Shooting
All electronic products have small problems, follow below steps can solve most of the small problems:
- Power off and restart the lamp can solve remote control small problems.
- Restarting the APP can solve APP small problems.
- Powering on and off the lamp can solve Bluetooth’s small problems.
- Disconnect controller: Press key A + D, RGBW flash 5 times slowly, disconnect successfully. Rematch controller with lamp: Press key A+ B, RGBW flash 3 times fast, rematch successfully.
- Once connect lamp successfully, for the next time use no need toconnect again, just open the APP. pull down to refresh the APP] interface is ok.
- One lamp only can control by one device, if need to control by another phone, need to remove the lamp in APP or On and Off lamp 3 times to reset.
Warm Tips: Please make sure the network is unblocked when connecting to the light.
Customer support
- Any more questions, please contact with us by below email: service@szelover.com
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,] pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection] against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>