JOY-iT SBC-BUCKBOOST01 Buck and Boost Voltage Transformer User Manual
- June 5, 2024
- JOY-It
Table of Contents
BUCK AND BOOST VOLTAGE TRANSFORMER
SBC-BuckBoost0
GENERAL INFORMATION
Dear customer, thank you very much for choosing our product.
In the following, we will introduce you to what to observe while starting up
and using this product.
Should you encounter any unexpected problems during use, please do not
hesitate to contact us.
DEVICE OVERVIEW
The freely configurable voltage transformer module is equipped with a “Step UP” and a “Step DOWN” function. The voltage can be set individually by means of a trimmer and is shown on the integrated segment display.
| Connections | Value range |
|---|
Input voltage
Input + | Input –| 5 – 25V
Output voltage
Output + | Output –| 0,5 – 25V
Maximum current| Input: 2A
Output: 2A
USE AND FUNCTIONS
Connect the cables of your power source to the input (Input + / Input -) of the voltage converter.
Next, connect the cables of the device to be supplied to the output ( **Output
- / Output -)**. The voltage converter is now ready for use.
The
desired voltage can be set with the adjustment screw. The display shows the
current output voltage.
With the S1 button, you can switch through a total of three display modes.
The factory setting automatically shows the input mode after starting the
device. Here, the input voltage is shown on the display. The LED, which is
located directly below the button, lights up permanently.
By pressing the button, you switch to the output mode. Here, the output
voltage is displayed and the LED goes out. Pressing the button again activates
the alternative mode. Here, the input and output modes are switched every
three seconds.
You can also press and hold the S1 key for three seconds to save the
current model. This will then be loaded automatically every time the device is
started in the future.
With the ON/OFF key, the voltage output can additionally be switched on or off.
The voltage
transformer can also be configured to automatically activate the output as
soon as the device is switched on. To activate this setting you must follow
the steps below:
- Turn on the device and switch on the output.
- By pressing the button “S1” you switch the device to “-1”.
- Now press and hold the “S1” button for three seconds until “[ 1]” appears.
ADDITIONAL INFORMATION
Our information and take-back obligations according to the Electrical and
Electronic Equipment Act (ElektroG)
The symbol on electrical and electronic equipment:
This crossed-out dustbin means that electrical and electronic appliances do
not belong in the household waste. You must return the old appliances to a
collection point.
Before handing over waste batteries and accumulators that are not enclosed by
waste equipment must be separated from it.
Return options:
As an end-user, you can return your old device (which essentially fulfills the
same function as the new device purchased from us) free of charge for disposal
when you purchase a new device.
Small appliances with no external dimensions greater than 25 cm can be
disposed of in normal household quantities independently of the purchase of a
new appliance. Possibility of return at our company location during opening
hours:
SIMAC Electronics GmbH, Pascalstr. 8, D-47506 Neukirchen-Vluyn, Germany
Possibility of return in your area:
We will send you a parcel stamp with which you can return the device to us
free of charge. Please contact us by email at Service@joy-
it.net or by telephone.
Information on packaging:
If you do not have suitable packaging material or do not wish to use your own,
please contact us and we will send you suitable packaging.
SUPPORT
If there are still any issues pending or problems arising after your purchase,
we will support you by e-mail, telephone, and with our ticket support system.
Email: service@joy-it.net
Ticket system: http://support.joy-it.net
Telephone: +49 (0)2845 9360-50 (10-17 o‘clock)
For further information please visit our website: www.joy-it.net
Published: 17.03.2022
www.joy-it.net
www.joy-it.net
SIMAC Electronics GmbH
Pascalstr. 8, 47506 Neukirchen-Vluyn
Pascalstr. 8 47506 Neukirchen-Vluyn
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>