Lazeny Hecto Drive 500XL Bicycle Headlight User Manual
- June 5, 2024
- Lazeny
Table of Contents
Lazeny Hecto Drive 500XL Bicycle Headlight
INTRODUCTION
READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new
Lezyne LED light. Traffic laws mandating lighting vary from country to
country. Inform yourself about ighting laws and regulations in the country of
use. Lezyne LED lights do not conform to the German road traffic regulation
Stvzo.
Warnings
- DO NOT L0OK DIRECTLY INTO LIGHT BEAM or shine into eyes of another. Lezyne LED Lights have a water resistance rating of IPX7 under IEC standard 60529. Submerging the device is not recommended. If moisture does enter the casing, air out until completely dry.
- DO NOT ATTEMPT TO REMOVE ELECTRONICS. Doing so will void warranty. Lezyne USA Inc. does not accept any liability for injuries or other damages resulting from the use of this product in any circumstances.
Warranty
In U.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the original purchase date to the original owner (proof of purchase required). Lezyne Batteries carry a six (6) month warranty from the original purchase date. Lezyne warranties cover any manutacturing defectsin materials or workmanship. Issues not covered by warranty include normal wear & tear, improper installation, attempting to access or modify electronics, damage or failure due to accident, misuse, abuse and/or neglect. For all warranty issues worldwide, please contact the retailer that sold the product. For any warranty questions Contact: warranty@lezvne.com
Mounting
Operation
- On/Off: hold button two (2) sec.
- Mode cycle: click button
RACE MODE (Micro only):
With the light OFF, hold button for five (5) seconds, until light flashes.
The light is now in Race Mode where only Overdrive and Economy outputs are
selectable. The light will remain in Overdrive Race Mode even when switched
OFF. Repeat the step above to return to the normal mode set.
MODE MEMORY:
The light remains in the output setting it is switched OFF in.
THERMAL PROTECTION:
If the operating temperature of the light is too high, the light auto-
matically lowers the lumen output.
Run Times and Modes
- MICRO
- HECTO
- MINI
Battery Indicator
An LED, located in the button, displays current battery status while light is
ON. When light is OFF, click button once to momentarily display battery
status.
Charging
- Before using your Lezyne LED Light for the first time, fully charge battery.
- To charge your light:
- Switch light OFF
- Remove USB protective cover Insert USB plug into powered USB port
- Once charging, button will flash green
- If button does not flash when plugged in, selected USB port may not be powered-try another USB port. Light will be charged after 3-4 hours or when button is solid green.
- Remove light from charger and reinstall USB protective cover-ensure USB protective cover is fully installed for water resistance
More Information
For more information on Lezyne products, visit: www.lezyne.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>