FinDreams Technology Company G3-3791200A-D1 Electronic Smart Key User Manual
- June 5, 2024
- FinDreams Technology Company
Table of Contents
FinDreams Technology Company G3-3791200A-D1 Electronic Smart Key User Manual
Product Overview
When the indicator light is normally on, it indicates that the electronic smart key is working normally; when the indicator light is dark, it indicates that the battery power is too low or the signal is too weak.
The main parameters
RF center frequency | 433.70-433.95MHz |
---|---|
RF modulation type | ASK |
RF transmit power | near field-9dbm~10dbm |
LF center frequency | 125±3KHz |
LF modulation type | ASK |
Protection class | IP5K7 |
Remote control distance | ≥30m |
Standard voltage | 3V |
Voltage range | 2.65V~3.6V |
Quiescent current | ≤6uA |
Operating current | ≤20mA |
FCC Warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>