BOSS AUDIO SYSTEM MRC10 Marine Radio Cover Instruction Manual
- June 5, 2024
- Boss Audio System
Table of Contents
MRC10
Installation Instructions
Marine Radio Cove
Thank you for purchasing a BOSS Audio Systems product. Please read through these instructions carefully so you will know how to install this product properly.
Package Contents
- 1x Marine radio cover
- 4x Mounting screws and clip nuts
- Installation Instructions and warranty
Introduction and Features
- Mounting cut-out in the dash (W x H): 8.7” x 3.3” ( 220 x 83 mm)
- Fits single DIN head units (W x H): 7” x 2.0” (178 x 51 mm)
- Marine radio cover dimensions (W x H x D): 10” x 4.1 x 2.6” (249 x 105 x 67 mm)
- Push-button activates auto-slide lens cover (spring activated door)
- UV-stabilized ABS plastic housing
- Impact-resistant ABS
- Sealed with an EVA gasket
Product Overview
Installation
Step 1
Remove two plastic tabs on the front of the marine radio cover to access four
mounting
screw holes. You need to fasten the radio cover to the dash through the screw
holes.
Note: Use a plastic prying tool to remove the tabs. Exercise caution when
prying the tabs off to prevent damage to the radio cover.
Step 2
Attach your head unit to the radio cover through the opening of the radio
cover. The opening fits a 7” x 2.0” head unit (single DIN). Make sure the head
unit is securely attached.
Step 3
Secure the radio cover in the dash through four screw holes (as described in
Step 1) using four supplied screws and clip nuts. The cut-out in the dash is
8.7” x 3.3” (W x H). Note: The top of the radio cover needs extra
clearance so that the spring-activated door can glide smoothly to the open
position (top opening).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>