Fleetpoint Gps Tracker Vl02 User Manual

Fleetpoint Gps Tracker Vl02

PRODUCT OVERVIEW

Position tracking

• GPS&LBS positioning
• Real-time location query

Anti-theft

• Ignition detection
• Power/Fuel cut-off
• SOS emergency call
• Power supply disconnection alert
• Geo-fence alert
• Towing alert
• Vibration alert

Configurable peripherals

• Vehicle door status alet
• Turn light/buzzer triggering
• Fuel level monitoring
• Temperature monitoring
• Driver behavior monitoring

SPECIFICATIONS

PRODUCT SETUP

Insert SIM
Remove the soft plug on one side of the device and insert the SIM card into the card slot.
Power on & off
Toggle the power switch besides the SIM slot to power on or off the device.

LED INDICATORS

GNSS STATUS (BLUE)

WIRELESS NETWORK AND SIM CARD STATUS (GREEN)

INTERFACE

WIRING INDICATORS

Power connection
The standard power supply ranges from 9V to 36VDC. During installation, negative side should connect to the ground.Do not connect with other ground wires simutaneously.

gnition wire
ACC line (orange) connects to vehicle’s ACC, detecting ignition. Be sure to check if it’s a real ignition wire i.e.power does not disappear after starting the engine.

Relay wiring
Relay’s white line (85) connects to the positive side of battery (12V) while the yellow line (86) connects to the device relay control (yellow line on the power cord).Find the fuel pump in the vehicle and cut off its positive power line. The positive side of fuel pump connects to the green line (87a) while the side closing to starter motor connects to green line (30), as the below chart. Switch of the two green lines have the same effect.

12V relay is standard. The device is suitable for vehicles with 12V Supply. If the vehicle power supply is 24V, use 24V relay.

Configuration

If you need to change the setting of the device, you can either text the command to the device, or use PC tool from supplier.
Note:
Texting command might be filtered by local carrier network deployment. In this case you can text through web management center provided by the carrier.

Common commands

PACKAGE AND STANDARD ACCESSORIES

INSTALLATION RECOMMENDATION

TROUBLESHOOTING

Warranty instructions

1. The warranty is valid only when the warranty card is properly completed, and upon presentation of the proof of purchase consisting of original invoice indicating the date of purchase, model and serial No.of the product. We reserve the right to refuse warranty if this information has been removed or changed after the original purchase of the product from the dealer.
2. Our obligations are limited to repair of the defect or replacement the defective part or at its discretion replacement of the product itself.
3. Warranty repairs must be carried out by our Authorized Service Centre. Warranty cover will be void, even if a repair has b attempted by any unauthorized service centre.
4. Repair or replacement under the terms of this warranty does not provide right to extension or renewal of the warranty period.
5. The warranty is not applicable to cases other than defects in material, design and workmanship.

Maintenance Record

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>