Shenzhen Dxr Electronic Technology DL013 Desk Lamp Wireless Charger Instructions
- June 5, 2024
- Shenzhen Dxr Electronic Technology
Table of Contents
Shenzhen Dxr Electronic Technology DL013 Desk Lamp Wireless
Charger
introduction
- Short press among cool light, Warm light,Neuter Mixed-light,OFF Long press cycle through brightness levels
- Wireless charging area
- Input
- Input: 9V 2A
- Wireless output:5W,7.5W,10W
- Lamp power:4W
- Power supply connected:Blue LED on
- Wireless charger is charging for mobile phone:
- Red LED on FOD :Red LED flashing
- Accessories:Type C‐USB cable
ISED Canada Statement:
This device contains licence-exempt trasnsmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada ‘s licence-exempt
RSS(8). Operation is subject to the
following two conditions: 1) this device may not cause interference and 2)
this device must accept any interference, including interference that may
cause undesired operation of the device.
Radiation Exposure: This equipment complies with Canada radiation exposure
limits set forth for an uncontrolled environment
RF Exposure Statement
To maintain compliance with IC’s RF Exposure guidelincs, This equipment should
be.installed and operated with minimum distance of 10cm the radiator your
body. This device and its antenna(s) must not be co-located or operation in
conjunction with any other antenna or transmitter
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiveris connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference recei ved, including interference that may cause undesired operation.
RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be installed and operated with minimum distance of 20cm the radiator
your body. This device and its antenna(s) must not be co-located or operation
in conjunction with any other antenna or transmitter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>