Shenzhen Dxr Electronic Technology WAC-DL017 Desk Lamp Wireless Charger User Manual
- June 5, 2024
- Shenzhen Dxr Electronic Technology
Table of Contents
Shenzhen Dxr Electronic Technology WAC-DL017 Desk Lamp Wireless Charger
Overview
- Short press among cool light, Warm light, Neuter Mixed-light, OFF Long press cycle through brightness levels
- Wireless charging area
- Input
Specifications
- Input: 9V 2A
- Wireless output: 5W,7.5W,10W
- Lamp power: 4W
- Power supply connected: Red LED on
- Wireless charger is charging for mobile phone： Blue LED on FOD :Red LED flashing
- Accessories: Type C‐USB cable
ISED Canada Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- this device may not cause interference and
- this device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure: This equipment complies with Canadian radiation exposure limits set forth for an uncontrolled environment
RF Exposure Statement
To maintain compliance with IC’s RF Exposure guidelines, This equipment should
be. installed and operated with a minimum distance of 10cm from the radiator
of your body. This device and its antenna(s) must not be co-located or
operated in conjunction with any other antenna or transmitter
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with t he instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged t o t ry to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation