KENWOOD KBP-5 Alkaline Battery Case Installation Guide
- June 5, 2024
- KENWOOD
Table of Contents
KBP-5 Alkaline Battery Case
INSTALLING/ REMOVING ALKALINE BATTERIES (KENWOOD KBP-5 OPTIONAL BATTERY CASE)
WARNING
- Do not install batteries in a hazardous environment where sparks could cause an explosion.
- Never discard batteries in the fire; extremely high temperatures can cause batteries to explode.
- Do not short circuit the battery case terminals.
- Do not use rechargeable batteries.
Note:
- If you do not plan to use the transceiver for a long period, remove the batteries from the battery case.
- This battery case has been designed for transmitting at a power of approximately 1 W (the low power setting on your transceiver). If you want to transmit a stronger signal (using the high power setting on your transceiver), use an optional rechargeable battery pack.
-
To open the battery case, press on the two tabs on the upper rear of the case, then pull the two halves apart.
-
Insert 6 AA (LR6) Alkaline batteries into the battery case.
● Be sure to match the polarities with those marked on the bottom of the battery case. -
Align the tabs of the cover with the base, then push down on the cover until it locks in place.
American Communication Systems
Discover the Power of Communications™
http://www.ameradio.com
Documents / Resources
|
KENWOOD KBP-5 Alkaline Battery
Case
[pdf] Installation Guide
KBP-5, Alkaline Battery Case, KBP-5 Alkaline Battery Case
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>