K RCHER IVC 60 30 Ap Industrial Vacuum Cleaner Instruction Manual

June 3, 2024
K RCHER

K RCHER IVC 60 30 Ap Industrial Vacuum Cleaner

Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent owners.

  • Before first start-up it is definitely necessary to read the safety indications Nr. 5.956-249.0!
  • The non-compliance of the operating and safety instructions may lead to damages of the appliance and to dangers for the operator and other persons.
  • In case of transport damage inform vendor immediately.

Environmental protection

  • The packaging material can be recycled. Please do not throw the packaging material into household waste; please send it for recycling.
  • Old appliances contain valuable materials that can be recycled; these should be sent for recycling. Batteries, oil, and similar substances must not enter the environment.
    Please dispose of your old appliances using appropriate collection systems.
    Notes about the ingredients (REACH) You will find current information about the ingredients
    at: www.kaercher.com/REACH

Danger or hazard levels

  • DANGER
    Immediate danger that can cause severe injury or even death.

  • WARNING
    Possible hazardous situation that could lead to severe injury or even death.

  • CAUTION
    Pointer to a possibly dangerous situation, which can lead to minor injuries.

  • ATTENTION
    Pointer to a possibly dangerous situation, which can lead to property damage

Proper use

WARNING
The appliance is not suitable for vacuuming dust which endangers health.

  • This vacuum cleaner is meant for dry and wet cleaning of floors and walls or to vacuum in production areas.
  • This appliance is suited for commercial and industrial use, e.g. in storage and assembly areas and on production machines.
  • The appliance is not approved for crane loading

Device elements

K RCHER IVC 60 30 Ap Industrial Vacuum Cleaner-FIG2

  1. Tension lever
  2. Filter cover
  3. Flat fold filter
  4. Right unlocking of the placement mechanics
  5. Power cord
  6. Suction head lock
  7. Handle for filter cleaning
  8. Steering roller of the dirt container
  9. Stopper
  10. Dirt receptacle
  11. Intermediate ring
  12. Left unlocking of the placement mechanics
  13. Impeller
  14. Suction support
  15. Steering roller of the chassis with parking brake
  16. Floor nozzle holder
  17. Chassis
  18. Handle of the dirt container
  19. Holder for suction pipe
  20. Handle of the suction head
  21. Rotating knob
  22. Suction head
  23. Torque motor
  24. Exhaust muffler
  25. Push handle
  26. Nameplate

Start up

  • Bring the appliance to working position – secure it,
    if required, with parking brakes.

  • Insert the suction hose (not included) into the suction
    hose connection.

  • Check the fill level in the dirt container prior to starting
    work and empty the container if necessary.

  • Ensure that the dirt container has been insertedproperly.

  • Attach the desired accessories (not included).

Power connection

CAUTION
Check direction of rotation of the engine at every socket change.

Note: With correct direction of rotation a strong airflow can be felt out of the opening of the exhaust muffler. Air is suctioned with incorrect rotation direction.

Illustration A

Check the direction of rotation of the motor. Exchange the poles on the appliance plug if the rotation direction is wrong

Operation

CAUTION
Risk of damage! Do not cover the supply and exhaust air openings on the suction head.

CAUTION
The two flat fold filters must never be removed during vacuuming.

Dirt receptacle

Note: The dirt container needs to be emptied if it is full until about 3 cm below the upper rim.
Check the fill level of the dirt container at regular intervals, as the appliance does not shut off automatically.

Dry vacuum cleaning

CAUTION
Please note the following when switching from wetto dry vacuum cleaning:
If you vacuum dry dust while the filter element is still wet the filter will become obstructed and may be damaged beyond repair.

  • Dry the wet filter properly before use or replace it with a dry one.
  • Change the filter, if required, according to instructions under the section “Maintenance and Care

Wet vacuum cleaning

Caution: Constantly monitor the fill level in the dirt receptacle when vacuuming high volumes of liquid, as the receptacle can be filled within a matter of seconds and could overflow.

CAUTION
Please observe the local provisions regarding the wastewater treatment.
After the wet vacuuming: Clean the flat-fold filter. Clean the container with a damp rag and dry it.

Rotating knob

| Appliance ON
---|---
| Appliance OFF

  • Plug in the mains plug.
  • Switch on the appliance at the rotating knob

Filter dedusting

Clean the flat fold filter at regular intervals.
Illustration B

  • Pull the handle of the filter clean-off out several times and reinsert it while the appliance is turned off.

Turn off the appliance

  • Switch off the appliance at the rotating knob.
  • Pull out the mains plug.
After each operation

Filter dedusting
Pull the handle of the filter clean-off out several times and reinsert it while the appliance is turned off.

Empty the container
Lock parking brakes

Illustration C

K RCHER IVC 60 30 Ap Industrial Vacuum Cleaner-FIG5

  • Pull the locks of the placement mechanics up.
  • Pull the push handle upward. The container is unlocked and lowered.

Illustration D

  • Pull the container out by the handle.
  • Empty the container.
  • Replace the battery and lock it with the sliding bow.

WARNING
Crush hazard. Never hold your hands between the dirt container and the intermediate ring or put them near the lifting mechanism while locking. Lock the container by pressing
the sliding bow with both hands.

Cleaning the device
Vacuum and wipe the appliance inside and outside with a damp cloth.

Storing the Appliance

  • Coil the mains cable and store it.
  • Wind the suction hose around the sliding bow.
  • Insert the floor nozzle and the suction pipe into their respective holder.
  • Place the appliance in a dry room and secure it from unauthorized use.

Transport

CAUTION
Risk of injury and damage! Observe the weight of the appliance when you transport it.

  • Release the park brakes and push the appliance by the push handle.
  • Grab the appliance by the chassis, not by the sliding bow to load it.
  • When transporting in vehicles, secure the appliance according to the guidelines from slipping and tipping over

Storage

CAUTION
Risk of injury and damage! Note the weight of the appliance in case of storage.
This appliance must only be stored in interior rooms

Care and maintenance

DANGER
First pull out the plug from the mains before carrying out any tasks on the machine.

Exchanging the flat pleated filter
Note: 2 persons are required to remove the suctionhead.

  • Release and remove the suction head.
  • Release and remove the filter cover.
  • Replace the flat pleated filter.
  • Insert and lock the filter cover.
  • Insert the suction head carefully, align and lock it.

Troubleshooting

DANGER
First pull out the plug from the mains before carrying out any tasks on the machine

Suction turbine does not run

  • Check cables, plugs, fuse, and socket.
  • Turn on the appliance.

Vacuum turbine is running but the machine is not sucking in dust/dirt
Note: With correct direction of rotation a strong airflow can be felt out of the opening of the exhaust muffler. Air is suctioned with incorrect rotation direction.

Illustration A

Check the direction of rotation of the motor. Exchange the poles on the appliance plug if the rotation direction is wrong

Suction capacity decreases

  • Remove blockages in the suction nozzle, suction tube, suction hose, or flat pleated filter.
  • Filter de dusting: Pull the handle out several times and reinsert it while the appliance is turned off.
  • Check the suction head and the receptacle for proper seating.
  • Replace the flat pleated filter

Dust comes out while vacuuming

  • Lock the filter cover.
  • Check the proper installation position of the flat fold filters.
  • Replace the flat pleated filter

Warranty

The warranty terms published by the relevant sales company are applicable in each country. We will repair potential failures of your appliance within the warranty period free of charge, provided that such failure is caused by faulty material or defects in manufacturing. In the event of a warranty claim please contact your dealer or the nearest authorized Customer Service center. Please submit the proof of purchase

Accessories and Spare Parts

Only use original accessories and spare parts, they ensure the safe and trouble-free operation of the device.For information about accessories and spare parts, please visit www.kaercher.com.

  • Accessories are not included in the delivery. The accessories for the device must be ordered separately, depending on the application.
  • You can procure the spare parts and the attachments from your dealer or your KÄRCHER branch office.

EU Declaration of Conformity

We hereby declare that the machine described below complies with the relevant basic safety and health requirements of the EU Directives, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the machine is modified without our prior approval

  • Product: Wet and dry vacuum cleaner
  • Type: 1.576-xxx
  • Relevant EU Directives
    • 2006/42/EC (+2009/127/EC)
    • 2011/65/EU
    • 2014/30/EU
  • Applied harmonized standards
    • EN 55014–1: 2017 + A11: 2020
    • EN 55014–2: 2015
    • EN 60335–1
    • EN 60335–2–69
    • EN IEC 61000–3–2: 2019
    • EN 61000–3–3: 2013 + A1: 2019
    • EN 62233: 2008
    • EN IEC 63000: 2018
  • Applied national standards

The undersigned act on behalf and under the power of attorney of the company management.

Managing Partner G. Schwarzenbach
Kärcher Industrial Vacuuming GmbH
Robert-Bosch-Straße 4-8 73550 Waldstetten (Germany)
Phone: +49 7171 94888-0
Fax: +49 7171 94888-528
Waldstetten, 2020/10/01

Declaration of Conformity (UK)

We hereby declare that the product described below complies with the relevant provisions of the following UK Regulations, both in its basic design and construc-tion as well as in the version put into circulation by us. This declaration shall cease to be valid if the product is modified without our prior approval.

  • Product: Wet and dry vacuum cleaner
  • Type: 1.576-xxx
  • Relevant UK Regulations
    • S.I. 2008/1597 (as amended)
    • S.I. 2012/3032 (as amended)
    • S.I. 2016/1091 (as amended)
  • Applied designated standards
    • EN 55014–1: 2017 + A11: 2020
    • EN 55014–2: 2015
    • EN 60335–1
    • EN 60335–2–69
    • EN IEC 61000–3–2: 2019
    • EN 61000–3–3: 2013 + A1: 2019
    • EN 62233: 2008
    • EN IEC 63000: 2018

Technical specifications

| IVC 60/30 Ap
---|---
Mains voltage| V| 400
Frequency| Hz| 3~ 50
Rated power| W| 3000
Container capacity| l| 60
Air volume (max.)| l/s| 68
Negative pressure (max.)| kPa (mbar)| 28,6 (286)
Type of protection| —| IP X4
Protective class| —| I
Suction hose connection (C-DN/C-ID)| DN| 70
Nominal width of suction hose| DN| 40/50/70
Length x width x height| mm| 970 x 690 x 1240
Filter area| m2| 1,9
Typical operating weight| kg| 95
Max. ambient temperature| °C| +40
Values determined to EN 60335-2-69
Sound pressure level LpA| dB(A)| 77
Uncertainty KpA| dB(A)| 1
Hand-arm vibration value| m/s2| <2,5
Uncertainty K| m/s2| 0,2
Power cord| H07RN-F 5×1,5 mm2|
Part no.:| Cable length
EU| 6.650-064.0| 5 m

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals