Joda KX-904VS 4-Person Hemlock Sauna Room Instruction Manual

: June 5, 2024
: Joda

Table of Contents

Precautions and Instructions
Installation Guide
Installation of the Sauna Room Body
Control Panel Instruction
Specification
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Joda KX-904VS 4-Person Hemlock Sauna Room Instruction Manual

Precautions and Instructions

ATTENTION

Please read all instructions thoroughly before using. Serious injury may result if ignore the following warning and instruction. Basic precautions should always be followed when using this electrical equipment.

DANGER

To avoid the risk of causing burns, fire, electric shock, or other injuries:

Connect the power cord to a properly grounded outlet.
Using only for its intended use as described in this manual.
Don’t use accessories not recommended by the manufacturer.
Please disconnect the power after using.
Please keep the electrical cord away from heated surfaces.
If the sauna is faulty, the supply cord or plug is damaged, please stop using it immediately.

WARNINGS

Don’t stay longer than one hour.
Don’t put the sauna on a humid environment.
Don’t touch the heater directly with hands or body for a long time.
Don’t use any sharp tools on or near the heaters (severe damage may result).
Placing the sauna on a flat surface.
Unauthorized disassembly of the sauna is prohibited.
People with health problems should consult a physician for prior to using the sauna. (Including acute diseases, malignant tumors, high blood pressure, heart disease, allergic dermatitis, pregnancy, etc.)
This product is not intended for use by person (including children) with reduced physical, sensory or mental capabilities, or lack of adequate experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
To be on the safe side, children should not use the sauna.
Using a sauna after taking alcohol, drugs, or medication can lead to
hyperthermia and increase the risk of death.
If you are feeling uncomfortable, exit the sauna immediately and consult a doctor.
Children should be supervised to ensure that they do not play with the appliance.

HYPERTHERMIA

Prolonged exposure in the sauna may cause hyperthermia. Hyperthermia occurs when body’s core temperature rises above 98.6F. Symptoms of hyperthermia include a riisein body temperature, dizziness, lethargy, drowsiness, and fainting. The effects of hyperthermia may include:

Failure to perceive heat / Unawareness of impending heat
Failure to recognize the need to exit the sauna
Fetal damage in pregnant women
Physical inability to exit the sauna
Unconsciousness

Installation Guide

Each panel is heavy, especially the top panel. Be careful to avoid injury when installing. This sauna requires at least 2 adults to complete assembly. There is a (+) button and a (–) button at the sides of each panel. Panels should be installed correspondently with one (+) to one (–) in the following way: The panel with the (+) button should be lifted up about 4 inches (10cm) higher than the panel with the(-) button (Picture 1); place the panel with (+) button against the panel with (–) button(Picture 2), and then slide down the panel with (+) button up against the two panels are flat and leveled (Picture 3). If they are not equal in height or there is an obvious gap between the two panels, which means they are not properly attached, and you should try again.
Installation instruction

The panels should be install in the following order:
Floor Panel → Back Panel → Left Panel → Right Panel →Bench Support Panel →Bench Surface Panel → Front Panel → Top Panel.

Installation of the Sauna Room Body

Place the floor panel on a flat surface (Note: Before installing wall and ceiling panels, make sure the floor is flat. If the surface is not flat, you may need shims to achieve a flat surface.) (Picture 1).(Picture2)
Snap the groove of the back panel into the tendons of the floor panel.(Picture3)
Place the side panel into the tenors of the floor panel, and make it fit into the back panel.(Picture4)
Place the front side panel on the tendons of floor panel, and make sure it is connection to the side panels.(Picture 5)
Clip the groove of the Bench Support panel into the tendons on both sides and connect the wires behind. (Picture 6&7）
Place the Bench surface panel.
Top panel fixed and wire connection.
- Make sure all side panels are in the slot of top panel, make sure all wires from side panels are not pressed in the slot.
- Make sure that all wires in the top panel are connected.
Plug in and power on to operate the sauna room