HEISE RGB PRO Metra Chasing LED Underglow Lighting User Manual
- June 5, 2024
- HEISE
Table of Contents
HEISE RGB PRO Metra Chasing LED Underglow Lighting User Manual
Heise Application Setup
Blue and Green LEDs not working like you think it should?
This is most likely due to the RGB signal sequence being out of phase in the
APP. To correct this issue, follow the steps below.
Configurations
Steps for all configurations
-
Turn on the controller(s) that need to be corrected.
-
Open the PRO RGB app on either an Android or iOS device.
-
Select the settings cog in the upper right corner.
-
Select “Chasing Settings” from the pop-out menu.
-
Scroll the “scroll to choice device” at the top of the screen to located the controller that needs to
be calibrated. -
Verify the “RGB Signal Sequence” is set to “RGB”.
-
Click the green “Setting” button to save.
- There are 2 options for the “RGB Signal Sequence” “RGB” and “RBG”. The “RBG” setting inverts the program sequencing for the blue and green color signals. When “RBG” is selected it
will cause the lighting product to illuminate Blue when Green is selected on the color wheel and illuminate Green when Blue is selected on the color wheel. This will also cause any color other than solid Red to illuminate inversely to the color wheel. Using this setting will not damage the controller or the lights. It is there as an Advanced Feature, to create an inverted color effect between multiple controllers.
- There are 2 options for the “RGB Signal Sequence” “RGB” and “RBG”. The “RBG” setting inverts the program sequencing for the blue and green color signals. When “RBG” is selected it
-
Click the back “<“ in the top left corner to return to the main app.
-
Power cycle the controller, by turning off the power source, then back on again.
-
Test functionality.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>