Kuzco Lighting PD85124 Ceiling LED Pendant Instructions
- June 5, 2024
- Kuzco Lighting
Table of Contents
Kuzco Lighting PD85124 Ceiling LED Pendant
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
- 120V input
Technical Support: 1-855-855-8926
INSTRUCTIONS
- Remove fixture from its original package
- Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2f)
- Attach mounting plate (1c) to electrical junction box (1a) using screws provided (1e) in hardware package
- Secure mounting plate (1c) to mounting surface with anchors (1f) and screws (1h)
- To change fixture height, push and hold wire gripper (2g), slide wire to desired length and then release wire gripper (2g) to secure
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package
- Attach canopy (2a) to mounting plate (1c) with canopy screws (2f)
- Fine tone wire length if necessary, by push and hold wire gripper (2g) and then adjust wire to desired length
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO
F: 604 538 7196
W: kuzcolighting.com
20220323
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>