Adeline FAN61T-3SP1 WHT 3 Speed Universal Remote Control Instruction Manual

: June 5, 2024
: Adeline

Table of Contents

Adeline FAN61T-3SP1 WHT 3 Speed Universal Remote Control
REMOTE CONTROL OPERATIONS
Instructions
Changing
3 SPEED UNIVERSAL REMOTE CONTROL
- REMOTE FUNCTIONS
Technical Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Adeline FAN61T-3SP1 WHT 3 Speed Universal Remote Control

Adeline-FAN61T-
3SP1-WHT-3-Speed-Universal-Remote-Control-product

REMOTE CONTROL OPERATIONS

Operate Fan Using Transmitter Code Pre-Set by Factory

Step 1. Power the ceiling fan on.
Step 2. Install two 1.5-volt AAA batteries.
Step 3. Press the button located on the front of the transmitter to operate the fan.
Step 4. Press the button to operate the light.

Note:
The blue light will illuminate to indicate the transmitter is working.

Instructions

Follow these instructions to

Change the transmitter code if you have interference with other fans and want to operate this fan only or
Re-sync the transmitter code if your fan is not working properly.

Step 1. Switch off the power of the fan.
Step 2. Switch on the power of the fan.
Step 3. Within 30 seconds, switch the lock /unlock switch on the back of the transmitter to the lock position and then push the sync button for about 5-10 seconds until the fan light kit flashes 3 times.

Changing

Changing from the Standard Remote FAN61T-3SP to Universal Remote FAN61T- 3SP1
To clear old codes, complete the process below 2 times with the remote control.

Step 1. Switch off the power to the fan.
Step 2. Switch on the power to the fan.
Step 3. Within 30 seconds, switch the lock /unlock switch on the back of the transmitter to the lock position and then push the sync button for about 5-10 seconds until the fan light kit flashes 3 times.

3 SPEED UNIVERSAL REMOTE CONTROL

REMOTE FUNCTIONS

This button controls the power to the light and also controls the dimming settings. Press and release the button to turn the light ON or OFF. Press and hold the button to set the desired brightness: the light will slowly illuminate to maximum light output and then stop when holding the button. Release the button and hold it again until it reaches minimal illumination where it will automatically stop again. The light button has an auto-resume, it will stay at the same brightness as the last time it was turned off.

Adeline-FAN61T-3SP1-WHT-3-Speed-Universal-Remote-Control-
fig-4

This button delays the light turning off for approximately 5 seconds, enabling you to exit your room before the light turns completely off.

For this fan, the dim switch should be in the “I” position, allowing for dimming of the light. Place the switch in the “0” position to turn the dimming feature oﬀ if you do not want the dimming feature.

Adeline-FAN61T-3SP1-WHT-3-Speed-Universal-Remote-Control-
fig-5

NOTE:
For convenience, the transmitter has been preset by the factory and is placed in unlock position initially. The receiver has been preset with a common code. The fan is ready for use. This transmitter can control any fan with this same initial setting.

The lock/unlock switch in the unlock position allows a common code to be sent.

In the unlocked position:
The transmitter will send a common code.

In lock position:
Allows a unique code to be sent to the receiver in the fan. Only the receiver of this fan will be synced with this transmitter in the lock position. More than one fan can be synced with one transmitter, in this case-follow sync instructions for each fan. Changing unlock/lock position will cause the code to change, and the receiver needs to synchronize again to have the same code, otherwise, the receiver will not respond to the transmitter.

NOTE:

To prevent damage to the transmitter, remove the batteries if not used for long periods.
Replace batteries as a simultaneous set – always replace the whole set of batteries at one time, taking care not to mix old and new ones or batteries of different types.
Please contact your local batteries recycling center for proper battery disposal information.

Technical Support

If you need any assistance with setup, operation, or parts for your new GOOD HOUSEKEEPING Ceiling Fan, please call us. Our technical support staff is ready to help! We are open 24 hours, 7 days a week.

USA: 1-888-880-3267 (FANS)
You may also reach us online at OceanAireHomeGoodsCompany.com. An electronic copy of this user manual can also be obtained online at OceanAireHomeGoodsCompany.com GOOD HOUSEKEEPING is a trademark of Hearst Communications, Inc. © 2022 Hearst Communications, Inc. All Rights Reserved.