Trex seal Ledger Tape with Aluminum Liner Instructions
- June 5, 2024
- Trex seal
Table of Contents
TREX SEAL INSTALLATION INSTRUCTIONS
INSTALLATION:
WHEN INSTALLING THE TREX RAIN ESCAPE DECK-DRAINAGE SYSTEM
1. Install the Trex RainEscape system. Mark a 5-1/2″ line above the ledger
board under the house wrap.| 2. Unroll the Trex Seal Ledger tape.
3. Fold the Trex Seal Ledge tape in half. Remove one of the release liners.
Press to seal against the vertical surface at the 5-1/2″ line.| 4. Once the
vertical surface is attached, remove the second release liner, unfold the Trex
Seal Ledger tape, and press firmly against the Trex RainEscape system.
WHEN NOT INSTALLING THE TREX RAIN ESCAPE DECK-DRAINAGE SYSTEM
1. Mark a 5-1/2″ line above the ledger board under the siding| 2. Unroll
the Trex Seal Ledger tape and fold in half. Remove one of
the release liners. Press to seal against the vertical surface.
3. Once the vertical surface is attached, remove the second release liner,
unfold the Trex Seal Ledger tape, and press firmly against the ledger.| 4.
With a utility knife or scissors, cut along each joist side and fold the tabs
down. Firmly press the cut tabs against the ledger.
For more information, visit trexseal.com
© 2022 Trex Company, Inc. All rights reserved. Trex® RainEscape® products are
manufactured and sold by IBP, LLC under a Trademark License Agreement with
Trex Company, Inc. RainEscape® is a federally registered trademark of IBP,
LLC.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>