VISUAL COMFORT PCD 5216 Orsay XL 5-Light Linear Chandelier Instruction Manual

VISUAL COMFORT PCD 5216 Orsay XL 5-Light Linear Chandelier

NOTICE

This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect items and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED)

• Phillips Screwdriver
• Wire Strippers
• Slotted Screwdriver
• Wire Cutters

ASSEMBLY INSTRUCTIONS

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove mounting plate (A) from the canopy (D) by removing the collar ring (E).

3. Install mounting plate (A) to the junction box and secure with mounting screws (C).

4. Feed electrical and ground wires through the bottom rod (H) and connect to the fixture body (I). Repeat for the middle rod (G), connecting to the bottom rod (H).

5. Continue feeding wires through collar ring (E) and canopy (D).

6. Holding fixture upright, slide collar ring (E) and canopy (D) down, and rest on fixture body (I). Then connect the top rod (F) to the middle rod (G). NOTE: Slide components down slowly to avoid damage.

7. Hang fixture swivel ball (K) to the center of mounting plate (A).

8. Cut excess wires, being sure to leave enough to reach the junction box. Separate wires, and strip insulation on each 5/8”.

9. Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (B).
   NOTE: It is imperative that the fixture is grounded.

10. Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (B).

11. Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (B).
    CAUTION: Do not reverse the hot and neutral connections.

12. Make sure all wire connections are tight, then carefully tuck them into the junction box.

13. Install canopy (D) to mounting plate (A) and secure with collar ring (E).

14. Install light bulb into the socket by lining up base to holes and twisting to secure.

15. Threaded diffusers (J) on socket bases.

Care Instructions

Clean only with a soft dry cloth or feather duster. Do Not use abrasive or chemical agents.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>