BOLD ARIA Z Bluetooth Speaker User Manual
- June 5, 2024
- BLU
Table of Contents
ARIA Z Bluetooth Speaker
User Manual
Product Name :
Speaker
Brand Name: BOLD
Model Name: BOLD ARIA Z
BOLD ARIA Z Bluetooth Speaker
Power on the speaker, LED will flash fast during the pairing process. Use the
handset to search “BOLD Aria Z” BT device, click connect. LED will off after
pairing successfully.
LED will flash slowly when out of rage
- Air hole
- Power on(R), Power off
- TF
- Mode control (BT/ USB)
- Volume down (long press)/ last song (signal click)
- Play/Pause
- LED
- Volume up (long click)/ next song (signal click)
Power on the switch to the right side, LED will be on. Power off the switch to
the left side.
Mode control: power on, insert TF card, default TF card model. If no TF card,
it is BT model.
Signal click M key, can choose TF model or BT model Charging: use Micro USB to
charge. Orange LED means charging, LED off means charging finish
**FCC Warning
**
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>