NEXTECH QM3752 TFT LCD Monitor with Remote Instruction Manual
- June 5, 2024
- Nextech
Table of Contents
**
**
NEXTECH QM3752 TFT LCD Monitor with Remote
WARNING
KEEP BUTTON BATTERIES OUT OF REACH OF CHILDREN
- If swallowed a lithium button battery may to lead to serious or fatal injury in as little as 2 hours, due to chemical burns and potential perforation of the oesophagus.
- Non-lithium button batteries battery can cause serious injuries if it is swallowed or placed inside any part of the body.
- All button batteries must be kept away from children regardless if they are new or used.
- If you suspect your child has swallowed or inserted a button battery immediately call the 24- hour Poisons Information Centre on 13 11 26 (Australia) or 0800 764 766 (New Zealand) for fast, expert advise.
- If your child is having difficulty breathing contact 000 (Australia) or 111 (New Zealand).
- Dispose of used button batteries immediately and safely out of the reach of children. A battery can still be dangerous even when it can no longer operate the device.
- As soon as you have finished using a button battery, put sticky tape around both sides of it. This will make it harder for children to swallow the button battery and avoid the risk of the battery catching fire.
- Immediately dispose of button batteries immediately out of reach of children, or recycle using a child resistant container and take used cells to your local battery collection centre.
SAFETY FIRST
For your safety, please operate this unit in accordance with your local road
and traffic regulations.
- Do NOT watch video while driving
- Do NOT install this product illegally
- Use responsibly
PRODUCT OVERVIEW
- Power
- Mode
- Decrease
- Menu
- Increase
FUNCTION & SPECIFICATIONS
- 7″ Digital LCD Panel, 16:9
- Resolution: 800×480 RGB
- Remote Control Included
- Video Standard: PAL & NTSC
- Video Sources: 2
- Power Supply: DC 12V
CONNECTION
- RCA(7″)
REMOTE CONTROL
- Power Button
- Switch Between Video 1 and Video 2
- Increase
- Menu
- Decrease
- Mode Selection
BRACKET INSTALLATION
-
Use screws to lock bracket to the desired installation location
-
Slide the metal head on the bracket into the gauge on the back of the monitor.
-
Once the monitor is placed at the right height, tighten the knob by turning it clockwise.
-
Untighten the knob on the ball head to change angle of the monitor.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>