Blue Marine Reef 350 Complete Kit Instruction Manual

: June 5, 2024
: Blue Marine

Table of Contents

Technical installation
Documents / Resources

Reef 350
Instruction Manual

Parts

Blue Marine Reef 350 Complete Kit - fig1

Safety

SAFETY REEF 350:

Read the manual of the stand and accessories carefully before usage.
Only suitable for indoor use.
Before filling the aquarium with water, ensure that it is placed on a solid surface that can support the load.
The aquarium must not be transported in a filled state because of the risk of glass breakage (no warranty coverage).

PARTS

1 Transit pipe
2 Transit pipe with a valve
3 Overflow transit with
coupling
4 Outflow pipe
5 Nozzle
6 Overflow pipe
7 Skimmer
8 Pump hose with coupling
9 Pump hose connector| 10 Pump
11 Float hose
12 Tap of water reservoir
13 Float
14 ProLED Lighting 2x
15 Tank
16 Sump
17 Water reservoir
18 Filter-sock
---|---

Technical installation

STEP 1

Place the aquarium (15) on the cabinet, and make sure the tank is aligned with the cabinet.
Make sure the aquarium is in its final position and horizontal, so it’s not necessary to move the aquarium anymore.
Make sure the aquarium is level. Blue Marine Reef 350 Complete Kit -
step1 STEP 2
Remove the doors.
Remove the center pillar by loosening the screw on the inside of the pillar and sliding the pillar out.
Mount (A) the float (13) in the sump (16).
Place the sump in the left compartment of the cabinet against the backside.

STEP 3

Place the transit pipe (1), the outflow pipe (4), and the overflow pipe (6) in the slots. Blue Marine Reef 350 Complete Kit - step3 STEP 4
Fit the transit pipe with valve (2) and the overflow transit (3) Blue Marine
Reef 350 Complete Kit - step4 STEP 5

| |
---|---|---
Screw the hose connector (9) into the pump (A).| Remove the filter cover (B) of the pump, it is not necessary with a marine aquarium.| Slide the hose (8) onto the hose connector (9).

STEP 6
Place the pump (10) in the appropriate section of the sump.

STEP 7

Connect the hose (8) to the outflow pipe (4) Place the nozzle (5) on the outflow pipe (4). STEP 8
Place the filter sock (18) and the skimmer (7) in the appropriate sections of the sump.

STEP 9
Assemble the water reservoir tap (12) on the water reservoir. Slide the float hose (11) to the tap.
STEP 10
Place the water reservoir (17) on the sump. Connect the float hose (11) to the float. Blue Marine Reef 350 Complete Kit - step10 The position of the float can be adjusted with the adjusting screw A). STEP 11
Place the ProLED (14) on the aquarium and fixate it with the screws STEP 12
The aquarium is now ready for use.

STEP 13
Open the tap of the transit pipe and fill the tank until the maximum water level has been reached in the sump. STEP 14
Fill the water reservoir (17) with osmosis water.
p meubel plaatsen
WARRANTY CONDITIONS:
This warranty is valid for 2 years on materials and incorrect construction. Only units with a fully filled-in warranty slip and official till receipt showing the date of purchase will be considered. You must supply the entire unit with accessories in the event of a warranty claim. We will inform you on a receipt whether the unit will be repaired or replaced. Aquadistri shall accept no liability for glass breakage or damage caused by negligence, incorrect use, transportation, incorrect set-up, or any subsequent modifications to the aquarium. No claims shall be assertible in excess of the value of the aquarium, in particular for damage to fish or corals.