kuzcolighting EW7024 LED Exterior Wall Sconce User Manual
- June 5, 2024
- kuzcolighting
Table of Contents
kuzco lighting EW7024 LED Exterior Wall Sconce
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- Use ELV (Electronic Low Voltage) type of dimmer for dimming application
Installation
- Remove the fixture from its original packaging
- Remove the mounting plate (1c) from within the fixture (2a) by loosening four screws (2b)
- Attach the mounting plate (1c) to the electrical junction box (1a), using the two screws (1e) provided in the hardware package.
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package
- Attach the fixture (2a) onto the mounting plate (1c) and secure it with four screws (2b)
- To prevent moisture from entering the outlet box and causing a short, seal around the top and side perimeter between the fixture and the wall surface with weather-resistant caulking (see illustration 1). The space at bottom should be left un-caulked to prevent moisture build-up.
Contact Information
- 19054 28th Avenue Surrey, BC Canada V3Z 6M3
- T: 604 538 7162
- TF: 1-855 85 KUZCO
- F: 604 538 7196
- W: kuzcolighting.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>