VISUAL COMFORT KW 2224 Precision 28 Inch Bath Light Instruction Manual
- June 5, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT KW 2224 Precision 28 Inch Bath Light
ASSEMBLY INSTRUCTIONS
Precision 28″ Bath Light
Item # KW 2224
NOTICE
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver Slotted Screwdriver
IMPORTANT INSTRUCTION
- Carefully remove all parts from the box. Place on a clean, soft surface.
- Remove mounting plate (A) from fixture by removing threaded caps (D).
- Install mounting plate (A) to the junction box and secure with mounting screws (B).
- Install shade (E) to fixture and secure with thumbscrews (C).
- Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (F).
- NOTE: It is imperative that the fixture is grounded.
- Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (F).
- Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (F).
- CAUTION: Do not reverse the hot and neutral connections.
- Make sure all wire connections are tight, then carefully tuck into the junction box.
- Install fixture to mounting plate (A) and secure with threaded caps (D).
- Remove protective covers (G) from shade (E).
Care Instructions:
- Clean only with a soft dry cloth or feather duster.
- Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>