visual comfort CHC5070 Modica XL Ring Chandelier Instructions
- June 5, 2024
- VISUAL COMFORT
Table of Contents
CHC5070 Modica XL Ring Chandelier
Instruction Manual
Modica XL Ring Chandelier
Item # CHC 5070
NOTICE
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install.
Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from the canopy (D) by removing collar ing (F).
-
Install mounting plate (B) to the junction box and secure with mounting screws (C).
-
Secure collar loop (E) to mounting plate (B) using pliers to tighten locknut.
-
Feed electrical and ground wires through the quick link (G) and bottom rod (I), then connect bottom rod (I) to fixture body (K) using quick links (G). Repeat for top rod (H), connecting to the bottom rod (I). Secure quick links (G).
-
Continue feeding wires through collar ring (F), and canopy (D).
-
Holding fixture upright, slide collar ring (G) and canopy (F) down, and rest on fixture body (K). Then connect top rod (H) to collar loop (E) using the quick link (G). Secure quick link (G).
NOTE: Slide components down slowly to avoid damage. -
Cut excess wires, being sure to leave enough to reach the junction box. Separate wires, and strip insulation on each 5/8”.
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
-
NOTE: It is imperative that the fixture is grounded.
-
Connect fixture neutral wire (ribbed) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (smooth with markings) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck them into the junction box.
-
Install canopy (D) to mounting plate (B) and secure with collar ring (F).
-
Install light bulbs into the sockets.
-
Clip shades (J) onto the bulbs.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do Not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>