Touratech KTM-1050 ADV Pannier Rack Instructions
- June 5, 2024
- Touratech
Table of Contents
Touratech KTM-1050 ADV Pannier Rack
Safety Precautions
We recommend having the accessory parts fitted by a specialist workshop.
| Caution
---|---
| Note
| Warning
| Liquid
| Torque
| Template
| 2 Persons
| Original motorcycle part
These instructions are written based on our current state of knowledge. Information is provided without any guarantee as to its accuracy. Subject to technical modifications.
The order of assembly steps must be followed.
Touratech accepts no liability for incorrectly fitted parts and resulting material damage or personal injury!
Please observe applicable road vehicle (construction and use) regulations as well as EC/ECE Directives and applicable laws in your country. If parts are fitted which require inspection and/or approval after fitting, take your vehicle to a testing station immediately and have the vehicle papers updated.
Check and if necessary tighten all bolted connections after 50 km.
Standard tightening torques in Nm for bolted connections with strength class 8.8.
For special tightening torques refer to your specialist workshop!
Please take into account that fitting panniers, crash bars, foot peg lowering kits (rider and pillion),Kickstand enlargmentplate, front spoilers and engine guards may restrict the bike’s lean angle!
If modifications are made to the fairing, stem, handlebar, fairing parts, etc., ensure that electrical wiring, brake lines, accelerator and clutch cables are refitted correctly. Check clearance, both sides with full steering lock.
Always disconnect the battery when working on the electrics!
We recommend cutting protective film to size and applying it to impact areas that are likely to be chipped by stones.
Work on the brake system and suspension should always be carried out by a specialist workshop.
The maximum load on luggage racks is 5 kg! Luggage racks Zega Pro TC is 10 kg!
If other original accessories or aftermarket accessories are used, ensure clearance, fitment and do not come into contact with other parts!
Apply conventional lubricant to stainless steel bolts prior to assembly.
PDF fitting instructions also can be downloaded from the Touratech webshop.
Mounting instructions
Contains:
– Bar end weight
– Control! wheel
– 2mm Allen Key
Installation
Remove right hand bar weight and replace it with the Kaoko Cruise control. Before fitting, please make sure that the friction control! wheel is adjusted upclose to the bar end. Fix Kaoko Cruise control with the original bar end screw.
With the Allen key you can adjust the friction of the nut.
Function
While rolling on the throttle, the friction nut can be gripped between the small finger and palm of the hand. This action tightens the nut and provides sufficient friction to fix the throttle to the desired position. (The friction stoll allows the opening and closing of the throttle, it just povides a slight rotational stiffnedd.
© January, 2022 by:
Touratech GmbH, Germany
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>