Govee H7061 RGBIC FLOOD LIGHTS User Manual
- June 5, 2024
- Govee
Table of Contents
H7061 RGBIC FLOOD LIGHTS
User Manual
READ AND SAVE THESE INSTRUCTIONS
Safety Instructions
- The flood light is rated as IP66 Waterproof. It can be used outdoors but cannot be immersed in water.
- The power adapter is not waterproof. Avoid exposing it to splashes, water drops, or high-humidity environments
- Tighten the waterproof cap before installing the flood lights
- The internal light sources of the light bars and strip light cannot be replaced. If the light sources sustain damage, the product should be replaced.
- Do not allow children to assemble and install this product without adult supervision
- Avoid installing this product near major heat sources.
- External dimmers cannot be used with this product
- Use this product with the provided power adapter only.
Introduction
Thanks for choosing Govee RGBIC Flood Lights. You can use Govee Home App to adjust light color, select modes, and set timers.
What You Get
Item | Quantity |
---|---|
Flood Lights | 2 |
Power Cable | 1 |
Ground Sticks | 2 |
Screws | 2 |
User Manual | 1 |
Service Card | 1 |
At a Glance
- Press to turn it on and off.
- Double press to switch color temperature to 6500K and maximize brightness.
- Press and hold for 5 seconds to reset.
Installing Your Flood Lights
Step 1. Attach the 2 flood lights to the control cable. Tighten the waterproof cable protector.
Note: Only when all two lights are attached on the control cable can this
device function properly.
Step 2. Attach a ground stake to the stand of each flood light.
Note: If you plan to install this product on very hard ground, please
separately purchase expansion bolts or metal stakes.
Step 3. Install each flood light on the ground and adjust the angle of its
beam.
Step 4. Plug the power adapter into power.
Note: Avoid placing the control box directly on the ground, otherwise the
Wi-Fi and Bluetooth connection may be intervened.
Tip: The two holes are reserved for you to mount the flood lights on the
wall, if necessary.
Please note that the accessories for mounting on the wall are not included.
Step 1 Select a suitable installation area on the wall and use an electric drill to make holes for attaching the mounting brackets.
Step 2 Insert a plastic screw cap into each hole. Next, align the mounting brackets with the drilled holes and screw caps, and screw the brackets into the wall.
Step 3 Plug the power adapter into power. The installation is now completed.
Pairing Your Device with Govee Home App
What You Need:
- A Wi-Fi router supports the 2.4GHz and 802.11 b/g/n bands (5GHz is not supported).
- A smartphone or tablet running iOS or Android.
Pairing Instructions
- Download Govee Home App from App Store (105) or Google Play (Android).
- Enable your smartphone’s Bluetooth.
- Open the app, tap the”+” icon in the top right corner and search for “H7061.”
- Tap the device icon and follow the on-screen instructions to complete the pairing.
Specifications
Power Input (Adapter) | AC 100-240V 50/60Hz 0.8A Max |
---|---|
Power Output (Adapter) | DC 24V/1A |
Power Cord Length | 32.8ft/10m |
Light Color | RGBWW |
Maximum Brightness | S00lm/per flood light (Color Temperature: 2200-6500K) |
Waterproof | Adapter (IPX0) |
Control Box (IPXS)
Flood Lights (IP66)
Working Temperature| -20-50°C/-4-122°F
Troubleshooting
-
Cannot connect to Govee Home App.
• Make sure the device is powered on.
• Make sure your smartphone’s Bluetooth has been enabled.
• Make sure your smartphone is connected to a 2.4GHz WiFi network.
• Position your smartphone close to the control box, then try connecting again. -
One or more floodlights fail to light up.
• Remove the light and then reattach it to the power cable. Also, unplug the power adapter and then plug it back into power.
• If the problem persists, please contact Govee Customer Service.
Customer Service
warranty: 12-Month Limited Warranty
support: Lifetime Technical support
Email: support@govee.com
Official Website: www.govee.com
@Govee @govee_official @govee.official @Goveeofficial @Govee.smarthome
FCC and ISED Canada Statement
This device complies with Part 15 of the FCC Rules and Industry Canada
licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC and IC Radiation Exposure Statement
This equipment complies with FCC and IC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
This Class B digital apparatus complies with Canadian ICES-005.
Cet appareil num~rique de la classe Best conforme a la norme NMB-005 du
Canada.
Responsible party :
Name: GOVEE MOMENTS(US) TRADING LIMITED
Address: 13013 WESTERN AVE STE S BLUE ISLAND IL 60406-2448
Email: support@govee.com
Contact information: https://www.govee.com/support
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by Shenzhen Intel Ii rocks Tech. Co., Ltd.
is under license.
Govee is a trademark of Shenzhen lntellirocks Tech Co., Ltd.
Copyright 02021 Shenzhen lntellirocks Tech Co., Ltd. All Rights Reserved.
Gove Home App
For FAQs and more information, please visit: www.govee.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>