Safety Rail SOURCE 2529 Kee Self Closing Gate Instruction Manual
- June 5, 2024
- Safety Rail SOURCE
Table of Contents
Safety Rail Source®
KEE® SELF-CLOSING GATE
INSTALLATION INSTRUCTIONS AND MATERIAL SPECIFICATIONS
OSHA Compliant
Tools Required: 1/2″ deep socket or wrench (u-bolt installation)
The steps below are a general guideline for a single gate installation on a
railing post up to 2″ square or round. Individual installation may vary;
therefore, the load capabilities of a gate are dependent on proper
installation and existing structure. Always field verifies completed
installation for adequate performance.
Step 1:
Loosely attach ladder safety gate hinge assemblies to the vertical column of
railing with u-bolts provided (or select appropriate field fasteners for other
types of installation). Do not tighten, as additional adjustments may be
required.
Step 2:
Adjust the top of the safety gate to match the top of the railing.
Step 3:
Align the hinge bracket to be perpendicular (90°) to the spring gate and
opening.
Step 4:
Adjust gate hoop to proper opening width. This can be achieved by selecting
any combination of two of the three bolt holes at the connection point for the
hinge plate and gate. Insure stop plate overlaps and contacts adjacent
vertical column of railing system (opposite of hinge side) allowing for
1/4″max. of clearance. Tighten carriage bolts once at the desired width.
Step 5:
Operate gate through full swing range to insure proper alignment before
permanent attachment. If mounting to pipe railing, tighten each u-bolt to 20
ft/lbs of torque and field verify for adequate attachment (all types of
installations).
Safety Rail Source 2570 Blvd of the Generals, Suite 200
Norristown, PA 19403 877-723-3766
www.safetyrailsource.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>