VISUAL COMFORT S 5115 Rivers Small Fluted Pendant Instruction Manual
- June 5, 2024
- VISUAL COMFORT
Table of Contents
S 5115 Rivers Small Fluted Pendant
Instruction Manual
ASSEMBLY INSTRUCTIONS
Rivers Small Fluted Pendant
Item # S 5115
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver
Slotted Screwdriver
Wire Cutters
Wire Strippers
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove canopy (F) from mounting plate (C) by removing collar ring (G).
-
Install mounting plate (C) to the junction box and secure with mounting screws (E).
-
Feed fixture wire and ground wire through the bottom rod (J) and connect to fixture body (L).
-
Continue feeding wires through collar ring (G), canopy (F), and top rod (I).
-
Holding fixture upright, slide collar ring (G) and canopy (F) down rod, and rest on fixture body (L). Connect top rod (I) to bottom rod (J).
NOTE: Slide components down slowly to avoid damage. -
Hang fixture swivel ball (H) to the center of mounting plate (C) and secure with bracket (B) and set screws (D).
-
Cut excess wires, being sure to leave about 12” to reach the junction box.
NOTE: Separate two sides of the molded wire, and strip insulation on each 5/8″. -
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (ribbed) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (smooth with markings) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck them into the junction box.
-
Install canopy (F) to mounting plate (C) by securing with collar ring (G).
-
Install the light bulb into the socket.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>