aiwa Exos Go Portable Bluetooth Speaker User Manual
- June 5, 2024
- Aiwa
Table of Contents
aiwa Exos Go Portable Bluetooth Speaker
Product parameters
| Operating range | 10m |
|---|---|
| Channel | Single |
| Impedance | 40 |
| Output power | SW |
| SNR | 80dB |
| Speaker unit | Diamet er 40mm |
| Audio | MP3/ WMA/ WAV |
| Battery capacity | 1500mAh |
| Play time | 6H |
| Material | Plastic |
| Product size | 8585103mm |
| N.W | 370g |
WARNING Always confirm that the temperature is 5′-40’c before you charge the battery.Please send it to professionals if there is something wrong.Do not overhaul by yourself.
Buttons and interfaces
- Turn on/off: Press and hold for 3 seconds
- Press for skip backward to the previous track Hold for volume up
- Press for skip forward to the next track Hold for volume down
- Play/button
- Bluetooth button
- Press to get in TWS mode
- lndicator
- 8.DC 5V input
- Aux IN
Connecting
Press and hold the on/off button. The speaker says “Powering on”. The blue LED
light will flash rapidly. Search on your Bluetooth devices and find “AIWA Exes
Go” to connect. You will hear a prompt “Connected”, which means the speakers
are successfully connected with your Bluetooth devices.
Indicator
- Blue light blinking fast: Ready to connect Blue light stays on: Connected successfully Blue light slow: Playing
- Green light blinking: Ready for pairing Green light stays on: Pairing successfully
- Orange light stays on: Charging Orange light stays off: Charging completed
TWS function
TWS feature allows you to pair two speakers together to create the ultimate surround sound experience.
Connection method:
Open aiwa Exos Go devices first, short press ” ~ ” button, you will hear a
short tone, then the spekers should automatically link together, you will hear
a ring to confirm the link was successful. You can connect your mobile phone
to the AIWA Exes Go after paired successful.
(Note: Do not use your mobile phone to connect the speaker until the two
speakers are paired.)
Bluetooth button
If the connection is slow, press the Bluetooth button twice to refresh or power on the speaker again. Then connecting again will speed up the connection.
ACCESSORIES
FCC Warning
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.