naeve 2048342 Loop Line LED Dimmable Floor Lamp Instruction Manual
- June 3, 2024
- naeve
Table of Contents
2048342 Loop Line LED Dimmable Floor Lamp
Instruction Manual
2048342 Loop Line LED Dimmable Floor Lamp
This product contains light sources of energy efficiency class “G”.
Safety instructions
Electrical connections may only be carried out by expert staff. The
manufacturers do not accept responsibility for injuries or defects caused by
improper use of a luminaire. The lamp is only for indoor use. The given mains
voltage may not be exceeded.
Attention! Before beginning any work on the lamp, disconnect it from the
mains power line by removing the fuse or unplugging the power plug. This also
applies to cleaning, maintenance, and replacing bulbs. Prior to starting
installation work, de-energize the power line – remove the fuse and/or set the
switch to “OFF. Lamps with transformers may be operated only with the original
transformer. Lamps become very hot in the area of the lighting point.
Therefore, never touch the lamp when it is switched on or still hot. RISK OF
INJURY FROM BURNS! The bulb may be replaced only by competent personnel. Use
only bulbs of the same type and voltage rating.
Lamps are not toys!
Children frequently do not recognize the dangers associated with electric
appliances or their packaging. Therefore, you should keep them away from
children. If you give this lamp to someone else, always include these
instructions. If the lamp is damaged, in particular the cord or lamp socket,
discontinue the use of the lamp immediately. In the event of a malfunction,
always have the lamp repaired by a qualified electrician. Never attempt to
repair the lamp yourself. Improper repairs can endanger the safety of the
user.
Protection class II . This luminaire is particularly
insulated and must not be connected to a protective earth terminal. Pay
attention to the fact that electric lines are not damaged during installation.
Only replace defective lamps with lamps of the same design, wattage, and
voltage. The care of luminaries is restricted to their surfaces. Use only a
dry cloth. Wetness must not get into wiring spaces or to current-carrying
parts. Plug and connection elements must be free of train and trick strengths.
Environmental protection!
Dispose of the lamp at the collection points designated for electronic waste.
m – »
N~ve Leuchten GmbH
Austra~e 5
D – 74670 Forchtenberg
www.naeve-leuchten.de