tangent PowerAmpster II Mini stereo power amplifier User Manual
- June 5, 2024
- tangent
Table of Contents
PowerAmpster II
Mini stereo power amplifier
User’s manual
PowerAmplifier:
- Power Indicator
- Switch Stereo/Mono (bridge mode)
- Line input RCA L/R
- Line input XLR L/R
- Speaker output bindingposts
- Power inlet
- On/Off switch
- Voltage switch
Including in the package:
Instruction Manual
Power Cable
Connect your device as a Stereo amplifier:
- Connect the power cord to the back of the amplifier then connect it to a wall outlet.
- Connect your preamplifier to Left/Right RCA (3) or XLR Output (4).
- Turn the power button to the On position, after two seconds the unit will enter working status and the standby indicator will light up.
Connect your device as a Mono amplifier:
- Connect the power cord to the back of the amplifier then connect it to a wall outlet.
- Connect your preamplifier’s Left output to Left RCA (3) or Left XLR Output (4).
- Connect speaker cables to the connectors marked BRIDGE MODE – & +
- Switch the Stereo/Mono switch to mono.
- Turn the power button to the On position, after two seconds the unit will enter working status and the standby indicator will light up. And do repeat the above for your preamplifier Right output to your second PowerAmpster II
Indicator Function
Power/Standby indicator
Power on: Push the power switch button on the rear panel at the “ON”
position the LED indicator will turn on. When the unit get an audio signal it
will automatically turn on. LED will be WHITE when the unit is active.
Standby:
The PowerAmpster II goes into auto standby when in-active in 15min, and it
will wake up again when it get input signal. LED will be RED when the unit is
inactive.
Power off:
Push the power source button at “OFF” position, and unit will go into power
off status.
Important Safety Instructions:
To reduce the risk of electrical shock, fire, etc.:
- Do not place the unit near any heat source such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- Do not block any ventilation openings of the unit.
- The unit shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the unit.
- Do not place any heavy loads onto the unit, and do not step on it, the load may fall and cause serious injury to the unit.
- Never unplug your unit by pulling on the power cord. Always grasp the plug firmly and pull it straight out from the outlet.
- Repair or replace all electric service cords that have become frayed or otherwise damaged immediately. Do not use a cord that shows cracks or abrasion damage along its length, the plug, or the connector end.
- To prevent fire or shock hazards, do not expose the unit to rain or moisture.
- During lightning or rainy days, unplug the unit for additional protection during thunderstorms or when the unit is not used for prolonged periods. This will prevent damage to the unit from lightning and power surges.
- Do not attempt to carry out any service work yourself. By opening or removing the cabinet, you may be exposed to dangerous voltage or other hazards. Any service work should be carried out by qualified technicians.
- In the interests of safety and to avoid unnecessary energy consumption, never leave the unit switched on while unattended for long periods of time, e.g. overnight, while on holiday, or while out of the house. Switch it off and disconnect the mains plug from the mains socket.
- Clean only with a dry cloth
- Please pay attention to the environmental aspects of battery disposal. The battery must be recycled or disposed of properly. This product must not be disposed of together with domestic waste. This product has to be disposed of at an authorized place for recycling electrical and electronic appliances. By collecting and recycling waste, you help save natural resources, and make sure the product is disposed of in an environmentally friendly and healthy way.
**** This symbol on the product or in the instructions means that your electrical and electronic equipment should be disposed of at the end of its life separately from your household waste. There are separate collection systems for recycling in the EU. For more information, please contact the local authority or your retailer where you purchased the product.
Product name:
Power supply:
Dimensions:
Weight:| Tangent PowerAmpster II
AC 100-120V~200-240V/50Hz
195 x 194 x 70mm
1,9 kg
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>