CHOETECH KH5S Portable Tripod Selfie Stick User Manual

CHOETECH KH5S Portable Tripod Selfie Stick

Product Overview

1. Phone Clip
2. Telescopic Shaft
3. Remote Control
4. Indicator Light
5. Shutter Button
6. Built-in Tripod
7. Fill Light (options)
8. Fixing Knob

Selfie Stick Introductions

Fill Light (options) 

Detachable Remote

Quick Steps for Remote

• Step 1: On your phone, tap Settings > Bluetooth, and then turn on the Bluetooth.
• Step 2: Hold down the shutter button (about 2s) until indicator light starts flashing to turn on the remote control.
• Step 3: Once the Bluetooth name of “Selfie” appears in the display, select it and tap “pair”.
• Step 4: Press the Shutter button to take photos. Step 5: Hold down the shutter button (about 3s) until indicator light goes out to turn off the remote control.
• Reminder: The remote control is compatible with Android 4.3, IOS 5.0 and later.

Replace the Battery

Reminder: The Bluetooth remote control has two types. Please follow the corresponding steps to replace the battery according to the type of your purchased product.

Covering Type
Force apart the upper shell at the groove on the side of the remote with fingernail, then replace the battery, and finally fasten the shell back.

Sliding Type
Slide the back cover in the direction of the arrow as shown, then replace a new battery, and finally insert the cover back.

Troubleshooting:

1. If your phone is unable to connect to the remote.
   Delete the Bluetooth pairing on your phone, reboot the remote and start a new device search.

2. If your Android phone can’t take photos when you press the shutter button,.
   Open the camera App and change the “Volume button function” to “Default” or “Shutter”.

Attention:

1. Don’t store the product in icy or damp environment.
2. Don’t place the product in the heat.
3. When replacing the battery, place the positive pole “+” of the battery outwards.
4. This product contains a battery, please place it out of the touch of infants to prevent children from swallowing it by mistake.
5. Don’t use the product in restricted district to avoid violating public order.

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the  following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Thanks for your support !

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>