Roku Smart Light Strip SE User Guide

: June 3, 2024
: Roku

Roku Smart Light Strip SE User Guide

Before you set up

Identify where you’re going to
mount your light strip and controller.

What’s included

A Roku Smart Light Strip SE

D Adhesive clips (x10)
E Alcohol wipes (x2)

B Power adaptor
C Controller

What you’ll need

Your smartphone
Scissors

Let’s get started

STEP 1: Prepare mounting location

Use the included alcohol wipes to clean your desired mounting location. Allow it to dry before proceeding to the next step.

STEP 2: Mount & connect controller

Peel off the adhesive backing and mount the controller where both the front and side buttons will be easily accessible. Keeping the light strip rolled, plug the end into the controller.

STEP 3: Mount strip

Unroll the strip, peeling off the adhesive backing and pressing firmly into place as you go. Use the included adhesive clips to reinforce the controller cables and strip, particularly around corners or anywhere the strip bends.

Corner installation

Avoid bending where the LED is located.

Pairing your strip

STEP 1: Download the Roku Smart Home app Scan the QR code below to download the Roku Smart
Home app on your smartphone. Sign in with your Roku account or create one.

STEP 2: Begin pairing

In the Roku Smart Home app, tap the “+” button, then “Add Device” to find “Light Strip.” With the power adaptor plugged into the wall, ensure the strip is
pulsing BLUE. If not, press and hold the controller’s side\ button until the status light flashes YELLOW and BLUE.

Strip hasn’t turned on?

Double check all of the connections to make sure they’re secure.

STEP 3: Finish pairing

Follow the instructions in the Roku Smart Home app to finish pairing the light strip to your account.

What’s that light mean?

Status Light	State
YELLOW and BLUE – Solid	In pairing mode
BLUE – Pulsing	Connecting to Wi-Fi®
BLUE – Solid	Light strip is on
NO LIGHT	Light strip is off
YELLOW – Flashing	Device is offline

How it works

Front Button	Side Button

Single press:

Change color

| Single press:

Power on/off

Long press:

Toggle mode

| Long press: Enter pairing mode

FCC WARNING

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving
Increase the separation between the equipment and
Connect the equipment into an outlet on a circuit different from that to which the receiver is
Consult the dealer or an experienced radio/TV technician for

FCC RADIATION EXPOSURE STATEMENT

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.

DISCLAIMER

The products, accessories, user interfaces, etc. illustrated in this guide are intended for reference only. Due to product updates, the actual product
and the illustrations in this guide may vary.