Interbath ITBDTM94024MB 40 Inch Wx24 Inch Metal Framed LED Single Bathroom Vanity Mirror Instruction Manual
- June 4, 2024
- Interbath
Table of Contents
Interbath ITBDTM94024MB 40 Inch Wx24 Inch Metal Framed LED Single
Bathroom Vanity Mirror
INSTRUCTION
HOW TO USED DEFOGGER SWITCH AND DIMMER SWITCH ?
- Short Touch Button (<1s) to turn the task light ON/OFF. white is ON, blue is OFF.
- Short Touch Button (<1s) to change color temperature from 2800K to 6000K, and cycle.
- Press the Button to turn the defogger ON/OFF. white is ON, blue is OFF.
ELECTRICAL SAFETY INSTRUCTIONS
All connections must be installed by a licensed electrician, in accordance
with current building codes. Consult a qualified electrician.
IMPORTANT: Always switch off the electrical supply at the main during
installation and maintenance. It is recommended that the circuit breaker is
switched off for the necessary circuit before installation commences.
Fitting in Bathrooms is subject to the appropriate building code Regulations.
This product is NOT suitable for outside zones. It is also Not suitable for
installation in saunas, steam rooms or shower cubicles. This product is only
suitable for permanent installation. DO NOT connect to a trailing plug and
socket outlet. This product is only suitable for indoor use. Do not attach the
product to surfaces that are damp or otherwise electrically conductive.
INSTALLATION CARE & SAFETY
Wear suitable eye protection when drilling. Take care when using power tools. Beware of hidden cables or pipes. Take care if drilling on tiled surfaces in case the drill slips. A piece of masking tape applied to the wall before marking out the fixing holes will stop the drill from wandering.
CLEANING
It is recommended that the unit is cleaned with a soft,dry, non abrasive cloth
when turned off. Never use cleaning agents or abrasive materials on any type of
surface finish. Do not allow moisture to come into contact with the electrical
components.
IMPORTANT
DO NOT strike glass components with hard or pointed items. DO NOT place very
hot or very cold items against or in close proximity to glass surfaces unless
an adequately thick insulation material is used to prevent such items coming
in contact with the glass. The nominal thickness of the mirror glass used in
this product is 1/4” and is film backed for safety. If the glass becomes
chipped or broken replace immediately.
INSTALLTION TOOLS NEEDED [
](https://manuals.plus/wp-content/uploads/2022/08
/Interbath-ITBDTM94024MB-Metal-Framed-LED-Single-Bathroom-Vanity-Mirror-3.png)
INSTALLTION MANUAL
STEP 01: Check the wall.Make sure that the wall is bearing walls that can
support the Mirror’s weight. Measure the width and height of the mirror back
holes/hocks distance with a tape measure.
STEP 02: Mark the punching position on the wall with a pencil. Use level
gauge make sure the hole at the same level.
STEP 03: Use impact drill punch holes in the marked center (6-8MM drill
bit),the drilling depth is about 5CM.Use a hammer to drive the expansion screw
into the drilled hote.
STEP 04: Use screwdriver screw the screw into the expansion screw,
tighten. And then leave a distance of about 5MM from the wall.
STEP 05: Hand the mirror up with screw. 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>